On Tue, May 09, 2023 at 12:02:05PM +0530, Manivannan Sadhasivam wrote:
> On Mon, May 08, 2023 at 08:01:36PM -0700, Bjorn Andersson wrote:
> > diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts b/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts
[..]
> > + sdc2_default_state: sdc2-default-state {
[..]
> > + card-detect-pins {
> > + pins = "gpio131";
> > + function = "gpio";
> > + drive-strength = <2>;
> > + bias-disable;
>
> Since the card detect is active low, shouldn't the pin be pulled high to avoid
> floating? Or is there an external pull up available on the board?
>
There's an external pull up resistor to vreg_s10b, so there shouldn't be
any reason to pull it internally as well.
Regards,
Bjorn
