From: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx>
sama5d2_icp populates an sst26vf064b SPI NOR flash. Its maximum operating
frequency for 2.7-3.6V is 104 MHz. As the flash is operated at 3.3V,
increase its maximum supported frequency to 104MHz. The increasing of the
spi-max-frequency value requires the setting of the
"CE# Not Active Hold Time", thus set the spi-cs-setup-ns to a value of 7.
The sst26vf064b datasheet specifies just a minimum value for the
"CE# Not Active Hold Time" and it advertises it to 5 ns. There's no
maximum time specified. I determined experimentally that 5 ns for the
spi-cs-setup-ns is not enough when the flash is operated close to its
maximum frequency and tests showed that 7 ns is just fine, so set the
spi-cs-setup-ns dt property to 7.
With the increase of frequency the reads are now faster with ~37%.
Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxx>
---
arch/arm/boot/dts/at91-sama5d2_icp.dts | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/at91-sama5d2_icp.dts b/arch/arm/boot/dts/at91-sama5d2_icp.dts
index 1346b8f2b259..999adeca6f33 100644
--- a/arch/arm/boot/dts/at91-sama5d2_icp.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_icp.dts
@@ -669,7 +669,8 @@ flash@0 {
#size-cells = <1>;
compatible = "jedec,spi-nor";
reg = <0>;
- spi-max-frequency = <80000000>;
+ spi-max-frequency = <104000000>;
+ spi-cs-setup-ns = <7>;
spi-tx-bus-width = <4>;
spi-rx-bus-width = <4>;
m25p,fast-read;
--
2.40.0.348.gf938b09366-goog
