Enable PCIe controllers and PHYs nodes on SM8550 MTP board. Co-developed-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx> Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx> --- This patch does not have a v3, but since it is now part of the same patchset with the controller and the phy drivers patches, I had to bump the version to 4. Latest version was here (v2): https://lore.kernel.org/all/20230118230526.1499328-3-abel.vesa@xxxxxxxxxx/ Changes since latest version (v2): * none Changes since v1: * ordered pcie related nodes alphabetically in MTP dts * dropped the pipe_mux, phy_pipe and ref clocks from the pcie nodes * dropped the child node from the phy nodes, like Johan suggested, and updated to use the sc8280xp binding scheme * changed "pcie_1_nocsr_com_phy_reset" 2nd reset name of pcie1_phy to "nocsr" * reordered all pcie nodes properties to look similar to the ones from sc8280xp arch/arm64/boot/dts/qcom/sm8550-mtp.dts | 29 +++++++++++++++++++++++++ 1 file changed, 29 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/sm8550-mtp.dts b/arch/arm64/boot/dts/qcom/sm8550-mtp.dts index 81fcbdc6bdc4..b69ded9c4b57 100644 --- a/arch/arm64/boot/dts/qcom/sm8550-mtp.dts +++ b/arch/arm64/boot/dts/qcom/sm8550-mtp.dts @@ -359,6 +359,35 @@ vreg_l3g_1p2: ldo3 { }; }; +&pcie_1_phy_aux_clk { + clock-frequency = <1000>; +}; + +&pcie0 { + wake-gpios = <&tlmm 96 GPIO_ACTIVE_HIGH>; + perst-gpios = <&tlmm 94 GPIO_ACTIVE_LOW>; + status = "okay"; +}; + +&pcie0_phy { + vdda-phy-supply = <&vreg_l1e_0p88>; + vdda-pll-supply = <&vreg_l3e_1p2>; + status = "okay"; +}; + +&pcie1 { + wake-gpios = <&tlmm 99 GPIO_ACTIVE_HIGH>; + perst-gpios = <&tlmm 97 GPIO_ACTIVE_LOW>; + status = "okay"; +}; + +&pcie1_phy { + vdda-phy-supply = <&vreg_l3c_0p91>; + vdda-pll-supply = <&vreg_l3e_1p2>; + vdda-qref-supply = <&vreg_l1e_0p88>; + status = "okay"; +}; + &pm8550_gpios { sdc2_card_det_n: sdc2-card-det-state { pins = "gpio12"; -- 2.34.1
