On 29.10.2022 07:14, Manivannan Sadhasivam wrote:
> Add thermal zones for the PM8280_{1/2} PMICs by using the temperature
> alarm blocks as the thermal sensors. Temperature trip points are
> inherited from PM8350 PMIC.
>
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>
Konrad
> arch/arm64/boot/dts/qcom/sc8280xp-pmics.dtsi | 44 ++++++++++++++++++++
> 1 file changed, 44 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-pmics.dtsi b/arch/arm64/boot/dts/qcom/sc8280xp-pmics.dtsi
> index 5de47b1434a4..397ff4995003 100644
> --- a/arch/arm64/boot/dts/qcom/sc8280xp-pmics.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sc8280xp-pmics.dtsi
> @@ -7,6 +7,50 @@
> #include <dt-bindings/interrupt-controller/irq.h>
> #include <dt-bindings/spmi/spmi.h>
>
> +/ {
> + thermal-zones {
> + pm8280_1_thermal: pm8280-1-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> + thermal-sensors = <&pm8280_1_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "critical";
> + };
> + };
> + };
> +
> + pm8280_2_thermal: pm8280-2-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> + thermal-sensors = <&pm8280_2_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "critical";
> + };
> + };
> + };
> + };
> +};
> +
> &spmi_bus {
> pmk8280: pmic@0 {
> compatible = "qcom,pmk8350", "qcom,spmi-pmic";
