On Wed, Jun 29, 2022 at 4:29 PM Aidan MacDonald <aidanmacdonald.0x0@xxxxxxxxx> wrote: > > Changes in v4: > > * Drop regmap-irq patches and rebase on top of the regmap-irq > refactoring series[1], which implements the same functionality. > * Reorder mfd_cells, putting one-line entries at the bottom. > * Fix incorrect example in axp192-gpio device tree bindings. > * Perform adc_en2 flag -> adc_en2_mask conversion in axp20x_adc > as a separate patch. > * Simplify axp192_usb_power_set_current_max(). > * Drop unneeded OF dependency in pin control driver, and document > tables used for describing register layouts. > * Various style fixups suggested by Andy Shevchenko. For patches 6-11 Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx> > [1]: https://lore.kernel.org/lkml/20220623211420.918875-1-aidanmacdonald.0x0@xxxxxxxxx/ > > Changes in v3: > > * Update pinctrl driver to address Andy Shevchenko's review comments > from v1, and fix a few other issues. > * Add gpio-ranges property and example snippet to gpio DT bindings. > * Update commit message of patch 01/16 to point out that all register > addresses are obtained using sub_irq_reg(). > * Document ccc_table in axp20x_battery. Also update commit message to > note a small fix that is part of that patch. > * Drop axp20x_adc consolidation patch in favor of using separate adc_raw > functions. It's a minor code size optimization that may not be worth > the effort due to implementation complexity. > * Use the FIELD_GET macro in axp20x_adc to further clarify intent. > * Fix a typo in the regulator driver where an AXP20X regulator ID was > mistakenly used instead of an AXP192 regulator ID. Also carry over > an Acked-by: tag from v1. Hope that's okay. > * Accumulate Acked-by: tags from v1 on DT patches. > * Accumulate Acked-by: tags from v2. > > Note that regmap maintainer Mark Brown has said the first two patches to > regmap-irq aren't suitable for inclusion into the kernel in their current > state. I'm including them for v3 so the series remains testable. > > Changes in v2: > > * Do a little cleanup of axp20x_adc suggested by Jonathan Cameron > * Consolidate ADC read functions in axp20x_adc > * Drop the axp192's read_label callback in axp20x_adc > * Clean up the axp192-gpio dt bindings > * Rewrite a problematic bit of code in axp20x_usb_power reported > by kernel test robot > * Support AXP192 in axp20x_battery > * Split up regmap-irq changes to two separate patches > > Cover letter from v1: > > Hi all, > > This patch series adds support for the X-Powers AXP192 PMIC to the > AXP20x driver framework. > > The first patch is a small change to regmap-irq to support the AXP192's > unusual IRQ register layout. It isn't possible to include all of the > IRQ registers in one regmap-irq chip without this. > > The rest of the changes are pretty straightforward, I think the only > notable parts are the axp20x_adc driver where there seems to be some > opportunities for code reuse (the axp192 is nearly a duplicate of the > axp20x) and the addition of a new pinctrl driver for the axp192, since > the axp20x pinctrl driver was not very easy to adapt. > > Aidan MacDonald (15): > dt-bindings: mfd: add bindings for AXP192 MFD device > dt-bindings: iio: adc: axp209: Add AXP192 compatible > dt-bindings: power: supply: axp20x: Add AXP192 compatible > dt-bindings: gpio: Add AXP192 GPIO bindings > dt-bindings: power: axp20x-battery: Add AXP192 compatible > mfd: axp20x: Add support for AXP192 > regulator: axp20x: Add support for AXP192 > iio: adc: axp20x_adc: Minor code cleanups > iio: adc: axp20x_adc: Replace adc_en2 flag with adc_en2_mask field > iio: adc: axp20x_adc: Add support for AXP192 > power: supply: axp20x_usb_power: Add support for AXP192 > pinctrl: Add AXP192 pin control driver > power: axp20x_battery: Add constant charge current table > power: axp20x_battery: Support battery status without fuel gauge > power: axp20x_battery: Add support for AXP192 > > .../bindings/gpio/x-powers,axp192-gpio.yaml | 68 ++ > .../bindings/iio/adc/x-powers,axp209-adc.yaml | 18 + > .../bindings/mfd/x-powers,axp152.yaml | 1 + > .../x-powers,axp20x-battery-power-supply.yaml | 1 + > .../x-powers,axp20x-usb-power-supply.yaml | 1 + > drivers/iio/adc/axp20x_adc.c | 356 +++++++++-- > drivers/mfd/axp20x-i2c.c | 2 + > drivers/mfd/axp20x.c | 152 +++++ > drivers/pinctrl/Kconfig | 13 + > drivers/pinctrl/Makefile | 1 + > drivers/pinctrl/pinctrl-axp192.c | 598 ++++++++++++++++++ > drivers/power/supply/axp20x_battery.c | 142 ++++- > drivers/power/supply/axp20x_usb_power.c | 84 ++- > drivers/regulator/axp20x-regulator.c | 100 ++- > include/linux/mfd/axp20x.h | 84 +++ > 15 files changed, 1547 insertions(+), 74 deletions(-) > create mode 100644 Documentation/devicetree/bindings/gpio/x-powers,axp192-gpio.yaml > create mode 100644 drivers/pinctrl/pinctrl-axp192.c > > -- > 2.35.1 > -- With Best Regards, Andy Shevchenko
