Re: [PATCH 1/2] i2c: designware: introduce a custom scl recovery for SoCFPGA platforms

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, May 18, 2022 at 03:22:16PM -0500, Dinh Nguyen wrote:
> The I2C pins on the SoCFPGA platforms do not go through a GPIO module,
> thus cannot be recovered by the default method of by doing a GPIO access.
> Only a reset of the I2C IP block can a recovery be successful.

...

>  #define MODEL_BAIKAL_BT1	BIT(9)
>  #define MODEL_AMD_NAVI_GPU	BIT(10)
> +#define MODEL_SOCFPGA		BIT(11)

...

> -#define MODEL_MASK		GENMASK(11, 8)

> +#define MODEL_MASK		GENMASK(12, 8)

Why this change is made?

...

> +	switch (dev->flags & MODEL_MASK) {
> +	case MODEL_SOCFPGA:
> +		rinfo->recover_bus = i2c_custom_scl_recovery;

_custom_ is too broad, use exact name, i.e.

	i2c_socfpga_scl_recovery

> +		break;
> +	default:
> +		rinfo->recover_bus = i2c_generic_scl_recovery;
> +		break;
> +	}

...

> +	{ .compatible = "intel,socfpga-i2c", .data = (void *)MODEL_SOCFPGA },

> +

Stray change.

-- 
With Best Regards,
Andy Shevchenko





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux