On 19/04/2022 06:33, Vinod Koul wrote:
> Add support for onboard MCP2517FD SPI CAN transceiver attached to
> SPI0 of RB3.
>
> Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> ---
> Changes in v2:
> - add cs and pinctrl config
> - remove misleading comment
>
> arch/arm64/boot/dts/qcom/sdm845-db845c.dts | 33 ++++++++++++++++++++++
> 1 file changed, 33 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> index 28fe45c5d516..4f4d45be93e3 100644
> --- a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> +++ b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> @@ -28,6 +28,13 @@ chosen {
> stdout-path = "serial0:115200n8";
> };
>
> + /* Fixed crystal oscillator dedicated to MCP2517FD */
> + clk40M: can_clock {
No underscores in node names.
> + compatible = "fixed-clock";
> + #clock-cells = <0>;
> + clock-frequency = <40000000>;
> + };
> +
> dc12v: dc12v-regulator {
> compatible = "regulator-fixed";
> regulator-name = "DC12V";
> @@ -746,6 +753,24 @@ codec {
> };
> };
>
> +&spi0 {
> + status = "okay";
> + pinctrl-names = "default";
> + pinctrl-0 = <&qup_spi0_default>;
> + cs-gpios = <&tlmm 3 GPIO_ACTIVE_LOW>;
> +
> + can@0 {
> + compatible = "microchip,mcp2517fd";
> + reg = <0>;
> + clocks = <&clk40M>;
> + interrupts-extended = <&tlmm 104 IRQ_TYPE_LEVEL_LOW>;
> + spi-max-frequency = <10000000>;
> + vdd-supply = <&vdc_5v>;
> + xceiver-supply = <&vdc_5v>;
> + status = "okay";
No need for status for new nodes (unless it is an extension of existing
node?), it is okay by default.
Best regards,
Krzysztof
