On Wed, 12 Jan 2022 19:16:02 +0100, Marek Behún wrote: > Common PHYs and network PCSes often have the possibility to specify > peak-to-peak voltage on the differential pair - the default voltage > sometimes needs to be changed for a particular board. > > Add properties `tx-p2p-microvolt` and `tx-p2p-microvolt-names` for this > purpose. The second property is needed to specify the mode for the > corresponding voltage in the `tx-p2p-microvolt` property, if the voltage > is to be used only for speficic mode. More voltage-mode pairs can be > specified. > > Example usage with only one voltage (it will be used for all supported > PHY modes, the `tx-p2p-microvolt-names` property is not needed in this > case): > > tx-p2p-microvolt = <915000>; > > Example usage with voltages for multiple modes: > > tx-p2p-microvolt = <915000>, <1100000>, <1200000>; > tx-p2p-microvolt-names = "2500base-x", "usb", "pcie"; > > Add these properties into a separate file phy/transmit-amplitude.yaml, > selecting it for validation if either of the `tx-p2p-microvolt`, > `tx-p2p-microvolt-names` properties is set for a node. > > Signed-off-by: Marek Behún <kabel@xxxxxxxxxx> > --- > .../bindings/phy/transmit-amplitude.yaml | 110 ++++++++++++++++++ > 1 file changed, 110 insertions(+) > create mode 100644 Documentation/devicetree/bindings/phy/transmit-amplitude.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: ./Documentation/devicetree/bindings/phy/transmit-amplitude.yaml:98:7: [warning] wrong indentation: expected 8 but found 6 (indentation) ./Documentation/devicetree/bindings/phy/transmit-amplitude.yaml:100:7: [warning] wrong indentation: expected 8 but found 6 (indentation) dtschema/dtc warnings/errors: doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/patch/1579281 This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit.
