From: Alexandru Tachici <alexandru.tachici@xxxxxxxxxx>
Add a tristate property to advertise desired transmit level.
If the device supports the 2.4 Vpp operating mode for 10BASE-T1L,
as defined in 802.3gc, and the 2.4 Vpp transmit voltage operation
is desired, property should be set to 1. This property is used
to select whether Auto-Negotiation advertises a request to
operate the 10BASE-T1L PHY in increased transmit level mode.
If property is set to 1, the PHY shall advertise a request
to operate the 10BASE-T1L PHY in increased transmit level mode.
If property is set to zero, the PHY shall not advertise
a request to operate the 10BASE-T1L PHY in increased transmit level mode.
Signed-off-by: Alexandru Tachici <alexandru.tachici@xxxxxxxxxx>
---
Documentation/devicetree/bindings/net/ethernet-phy.yaml | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 2766fe45bb98..2bb3a96612a2 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -77,6 +77,15 @@ properties:
description:
Maximum PHY supported speed in Mbits / seconds.
+ an-10base-t1l-2.4vpp:
+ description: |
+ tristate, request/disable 2.4 Vpp operating mode. The values are:
+ 0: Disable 2.4 Vpp operating mode.
+ 1: Request 2.4 Vpp operating mode from link partner.
+ Absence of this property will leave configuration to default values.
+ $ref: "/schemas/types.yaml#/definitions/uint32"
+ enum: [0, 1]
+
broken-turn-around:
$ref: /schemas/types.yaml#/definitions/flag
description:
--
2.25.1
