Currently, if the GPIO is configured as output in the bootloader and user changes the mode to input in HLOS, it would end up getting configured as input/output. Functionally, this is fine; however, there may be some requirements where the output needs to be disabled so that it can be used only for input. Add support to enable/disable output mode through "output-enable" or "output-disable" pinctrl properties. Signed-off-by: Subbaraman Narayanamurthy <quic_subbaram@xxxxxxxxxxx> --- drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-) diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c index 98bf0e2..39a18aa 100644 --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c @@ -1,6 +1,6 @@ // SPDX-License-Identifier: GPL-2.0-only /* - * Copyright (c) 2012-2014, The Linux Foundation. All rights reserved. + * Copyright (c) 2012-2014, 2021, The Linux Foundation. All rights reserved. */ #include <linux/gpio/driver.h> @@ -424,6 +424,9 @@ static int pmic_gpio_config_get(struct pinctrl_dev *pctldev, return -EINVAL; arg = 1; break; + case PIN_CONFIG_OUTPUT_ENABLE: + arg = pad->output_enabled; + break; case PIN_CONFIG_OUTPUT: arg = pad->out_value; break; @@ -503,6 +506,9 @@ static int pmic_gpio_config_set(struct pinctrl_dev *pctldev, unsigned int pin, case PIN_CONFIG_INPUT_ENABLE: pad->input_enabled = arg ? true : false; break; + case PIN_CONFIG_OUTPUT_ENABLE: + pad->output_enabled = arg ? true : false; + break; case PIN_CONFIG_OUTPUT: pad->output_enabled = true; pad->out_value = arg; -- 2.7.4
