On Mon 13 Sep 21:57 CDT 2021, Subbaraman Narayanamurthy wrote: > Currently, if the GPIO is configured as output in the bootloader > and user changes the mode to input in HLOS, it would end up > getting configured as input/output. Functionally, this is fine; > however, there may be some requirements where the output needs > to be disabled so that it can be used only for input. > > Add support to enable/disable output mode through "output-enable" > or "output-disable" pinctrl properties. > > Signed-off-by: Subbaraman Narayanamurthy <quic_subbaram@xxxxxxxxxxx> Reviewed-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Regards, Bjorn > --- > drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 8 +++++++- > 1 file changed, 7 insertions(+), 1 deletion(-) > > diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > index 98bf0e2..39a18aa 100644 > --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > @@ -1,6 +1,6 @@ > // SPDX-License-Identifier: GPL-2.0-only > /* > - * Copyright (c) 2012-2014, The Linux Foundation. All rights reserved. > + * Copyright (c) 2012-2014, 2021, The Linux Foundation. All rights reserved. > */ > > #include <linux/gpio/driver.h> > @@ -424,6 +424,9 @@ static int pmic_gpio_config_get(struct pinctrl_dev *pctldev, > return -EINVAL; > arg = 1; > break; > + case PIN_CONFIG_OUTPUT_ENABLE: > + arg = pad->output_enabled; > + break; > case PIN_CONFIG_OUTPUT: > arg = pad->out_value; > break; > @@ -503,6 +506,9 @@ static int pmic_gpio_config_set(struct pinctrl_dev *pctldev, unsigned int pin, > case PIN_CONFIG_INPUT_ENABLE: > pad->input_enabled = arg ? true : false; > break; > + case PIN_CONFIG_OUTPUT_ENABLE: > + pad->output_enabled = arg ? true : false; > + break; > case PIN_CONFIG_OUTPUT: > pad->output_enabled = true; > pad->out_value = arg; > -- > 2.7.4 >
