On Fri 03 Sep 11:09 PDT 2021, AngeloGioacchino Del Regno wrote:
> All of the devices in the Sony Yoshino platform are using a Synaptics
> RMI4-compatible touch IC with identical pins and supplies: enable the
> I2C-5 bus and add the rmi4-i2c node along with the required pin
> configurations.
>
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxxx>
> Reviewed-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
> ---
> .../dts/qcom/msm8998-sony-xperia-yoshino.dtsi | 60 +++++++++++++++++++
> 1 file changed, 60 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/msm8998-sony-xperia-yoshino.dtsi b/arch/arm64/boot/dts/qcom/msm8998-sony-xperia-yoshino.dtsi
> index b07cbc759807..2fe53e4675d5 100644
> --- a/arch/arm64/boot/dts/qcom/msm8998-sony-xperia-yoshino.dtsi
> +++ b/arch/arm64/boot/dts/qcom/msm8998-sony-xperia-yoshino.dtsi
> @@ -30,6 +30,15 @@ board_vbat: vbat-regulator {
> regulator-boot-on;
> };
>
> + touch_vddio_vreg: touch-vddio-vreg {
> + compatible = "regulator-fixed";
> + regulator-name = "touch_vddio_vreg";
> + startup-delay-us = <10000>;
> + gpio = <&tlmm 133 GPIO_ACTIVE_HIGH>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&ts_vddio_en>;
> + };
> +
> vph_pwr: vph-pwr-regulator {
> compatible = "regulator-fixed";
> regulator-name = "vph_pwr";
> @@ -134,6 +143,42 @@ ramoops@ffc00000 {
> };
> };
>
> +&blsp1_i2c5 {
> + status = "okay";
> + clock-frequency = <355000>;
> +
> + touchscreen: synaptics-rmi4-i2c@2c {
"touchscreen" sounds like a better "generic name" for the node.
Haven't checked the following patches yet, do you need the label?
Regards,
Bjorn
> + compatible = "syna,rmi4-i2c";
> + reg = <0x2c>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + interrupts-extended = <&tlmm 125 IRQ_TYPE_EDGE_FALLING>;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&ts_int_n>;
> +
> + vdd-supply = <&vreg_l28_3p0>;
> + vio-supply = <&touch_vddio_vreg>;
> +
> + syna,reset-delay-ms = <220>;
> + syna,startup-delay-ms = <1000>;
> +
> + rmi4-f01@1 {
> + reg = <0x01>;
> + syna,nosleep-mode = <1>;
> + };
> +
> + rmi4-f11@11 {
> + reg = <0x11>;
> + syna,sensor-type = <1>;
> + };
> + };
> +};
> +
> +&blsp1_i2c5_sleep {
> + bias-disable;
> +};
> +
> &blsp2_uart1 {
> status = "okay";
> };
> @@ -448,6 +493,21 @@ hall_sensor0_default: acc-cover-open {
> drive-strength = <2>;
> input-enable;
> };
> +
> + ts_int_n: ts-int-n {
> + pins = "gpio125";
> + function = "gpio";
> + drive-strength = <8>;
> + bias-pull-up;
> + };
> +
> + ts_vddio_en: ts-vddio-en-default {
> + pins = "gpio133";
> + function = "gpio";
> + bias-disable;
> + drive-strength = <2>;
> + output-low;
> + };
> };
>
> /*
> --
> 2.32.0
>
