While enabling EDAC support for the LS1028A it was discovered that the
memory node has a wrong endianness setting as well as a wrong interrupt
assignment. Fix both.
This was tested on a sl28 board. To force ECC errors, you can use the
error injection supported by the controller in hardware (with
CONFIG_EDAC_DEBUG enabled):
# enable error injection
$ echo 0x100 > /sys/devices/system/edac/mc/mc0/inject_ctrl
# flip lowest bit of the data
$ echo 0x1 > /sys/devices/system/edac/mc/mc0/inject_data_lo
Fixes: 8897f3255c9c ("arm64: dts: Add support for NXP LS1028A SoC")
Signed-off-by: Michael Walle <michael@xxxxxxxx>
---
arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
index 9506f0669ead..040a3e529bf1 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
@@ -197,8 +197,8 @@
ddr: memory-controller@1080000 {
compatible = "fsl,qoriq-memory-controller";
reg = <0x0 0x1080000 0x0 0x1000>;
- interrupts = <GIC_SPI 144 IRQ_TYPE_LEVEL_HIGH>;
- big-endian;
+ interrupts = <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>;
+ little-endian;
};
dcfg: syscon@1e00000 {
--
2.20.1
