Hi Geert,
Thanks for the feedback.
> Subject: Re: [PATCH 1/2] arm64: dts: renesas: hihope-rzg2-ex: Drop rxc-
> skew-ps from ethernet-phy node
>
> Hi Biju,
>
> On Thu, Oct 15, 2020 at 3:24 PM Biju Das <biju.das.jz@xxxxxxxxxxxxxx>
> wrote:
> > HiHope RZG2[HMN] boards uses Realtek phy and the driver does not
> > support rxc-skew-ps property. So remove rxc-skew-ps from ethernet-phy
> node.
> >
> > Fixes: 7433f1fb8ec8fe ("arm64: dts: renesas: Add HiHope RZ/G2M sub
> > board support")
> > Signed-off-by: Biju Das <biju.das.jz@xxxxxxxxxxxxxx>
> > Reviewed-by: Lad Prabhakar <prabhakar.mahadev-
> lad.rj@xxxxxxxxxxxxxx>
>
> Thanks for your patch!
>
> > --- a/arch/arm64/boot/dts/renesas/hihope-rzg2-ex.dtsi
> > +++ b/arch/arm64/boot/dts/renesas/hihope-rzg2-ex.dtsi
> > @@ -23,7 +23,6 @@
> > status = "okay";
> >
> > phy0: ethernet-phy@0 {
> > - rxc-skew-ps = <1500>;
> > reg = <0>;
> > interrupt-parent = <&gpio2>;
> > interrupts = <11 IRQ_TYPE_LEVEL_LOW>;
>
> Should "rx-internal-delay-ps = <1800>" be added to the avb node instead
> (after [1] has entered v5.10-rc1, and the DTS part of [2] has been applied to
> renesas-devel)?
Looking at the schematic, it is not needed, since it has "2ns" internal delay (4.7K Ohm latched to 2.5 V) on the Rx side.
Cheers,
Biju
> [1] [PATCH net-next v4 resend 5/5] ravb: Add support for explicit internal
> clock delay configuration
> https://lore.kernel.org/linux-renesas-soc/20201001101008.14365-6-
> geert+renesas@xxxxxxxxx/
> [2] [PATCH v3 0/7] net/ravb: Add support for explicit internal clock delay
> configuration
> https://lore.kernel.org/linux-renesas-soc/20200819134344.27813-1-
> geert+renesas@xxxxxxxxx
>
> Gr{oetje,eeting}s,
>
> Geert
>
> --
> Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-
> m68k.org
>
> In personal conversations with technical people, I call myself a hacker. But
> when I'm talking to journalists I just say "programmer" or something like that.
> -- Linus Torvalds
