Hi Prabhakar,
Thank you for the patch.
On Mon, Apr 06, 2020 at 05:42:38PM +0100, Lad Prabhakar wrote:
> Modes in the driver are based on xvclk frequency fixed to 24MHz, but where
> as the OV5645 sensor can support the xvclk frequency ranging from 6MHz to
> 24MHz. So instead making clock-frequency as dt-property just let the
> driver enforce the required clock frequency.
>
> Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
> ---
> drivers/media/i2c/ov5645.c | 14 +++++---------
> 1 file changed, 5 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/media/i2c/ov5645.c b/drivers/media/i2c/ov5645.c
> index a6c17d15d754..52848fff8a08 100644
> --- a/drivers/media/i2c/ov5645.c
> +++ b/drivers/media/i2c/ov5645.c
> @@ -61,6 +61,8 @@
> #define OV5645_SDE_SAT_U 0x5583
> #define OV5645_SDE_SAT_V 0x5584
>
> +#define OV5645_XVCLK_FREQ 24000000
> +
> /* regulator supplies */
> static const char * const ov5645_supply_name[] = {
> "vdddo", /* Digital I/O (1.8V) supply */
> @@ -1094,25 +1096,19 @@ static int ov5645_probe(struct i2c_client *client)
> return PTR_ERR(ov5645->xclk);
> }
>
> - ret = of_property_read_u32(dev->of_node, "clock-frequency", &xclk_freq);
> + ret = clk_set_rate(ov5645->xclk, OV5645_XVCLK_FREQ);
> if (ret) {
> - dev_err(dev, "could not get xclk frequency\n");
> + dev_err(dev, "could not set xclk frequency\n");
> return ret;
> }
> -
I think you can keep the blank line here.
Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
> /* external clock must be 24MHz, allow 1% tolerance */
> + xclk_freq = clk_get_rate(ov5645->xclk);
> if (xclk_freq < 23760000 || xclk_freq > 24240000) {
> dev_err(dev, "external clock frequency %u is not supported\n",
> xclk_freq);
> return -EINVAL;
> }
>
> - ret = clk_set_rate(ov5645->xclk, xclk_freq);
> - if (ret) {
> - dev_err(dev, "could not set xclk frequency\n");
> - return ret;
> - }
> -
> for (i = 0; i < OV5645_NUM_SUPPLIES; i++)
> ov5645->supplies[i].supply = ov5645_supply_name[i];
>
--
Regards,
Laurent Pinchart
