From: Vasily Khoruzhick <anarsoul@xxxxxxxxx> Add binding document for bluetooth part of RTL8723BS/RTL8723CS Signed-off-by: Vasily Khoruzhick <anarsoul@xxxxxxxxx> Signed-off-by: Alistair Francis <alistair@xxxxxxxxxxxxx> --- .../bindings/net/realtek,rtl8723bs-bt.yaml | 56 +++++++++++++++++++ 1 file changed, 56 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/realtek,rtl8723bs-bt.yaml diff --git a/Documentation/devicetree/bindings/net/realtek,rtl8723bs-bt.yaml b/Documentation/devicetree/bindings/net/realtek,rtl8723bs-bt.yaml new file mode 100644 index 000000000000..9e212954f629 --- /dev/null +++ b/Documentation/devicetree/bindings/net/realtek,rtl8723bs-bt.yaml @@ -0,0 +1,56 @@ +# SPDX-License-Identifier: GPL-2.0 +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/net/realtek,rtl8723bs-bt.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: RTL8723BS/RTL8723CS Bluetooth Device Tree Bindings + +maintainers: + - Vasily Khoruzhick <anarsoul@xxxxxxxxx> + - Alistair Francis <alistair@xxxxxxxxxxxxx> + +description: + RTL8723CS/RTL8723CS is WiFi + BT chip. WiFi part is connected over SDIO, while + BT is connected over serial. It speaks H5 protocol with few extra commands + to upload firmware and change module speed. + +properties: + compatible: + oneOf: + - "realtek,rtl8723bs-bt" + - "realtek,rtl8723cs-bt" + + device-wake-gpios: + description: + GPIO specifier, used to wakeup the BT module (active high) + + enable-gpios: + description: + GPIO specifier, used to enable the BT module (active high) + + host-wake-gpios: + desciption: + GPIO specifier, used to wakeup the host processor (active high) + +firmware-postfix: firmware postfix to be used for firmware config +reset-gpios: GPIO specifier, used to reset the BT module (active high) + +required: + - compatible + +examples: + - | + &uart1 { + pinctrl-names = "default"; + pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>; + status = "okay"; + + bluetooth { + compatible = "realtek,rtl8723bs-bt"; + reset-gpios = <&r_pio 0 4 GPIO_ACTIVE_LOW>; /* PL4 */ + device-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_HIGH>; /* PL5 */ + host-wakeup-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */ + firmware-postfix="pine64"; + }; + }; -- 2.25.1
