Hi Tony, The following is a revised series of the ti-sysc support for PRUSS. Please refer to the original series cover-letter [1] for details. Following are the main changes in v2: - Drop the enabling of the interconnect nodes from various AM335x and AM437x board dts files (last 7 patches from original series) - Enable the target-module node for AM437x by default. None of the current AM437x board dts files use AM4372, so there should not be any regressions. We can drop the status=disabled in the am33xx.dtsi file once we add the SoC revision support for AM335x SoCs. This is already disabled before the series as well. I have identified a few boards which use the older SoCs that can disable the node in dts, but there were few others which can use any of the SoCs, so those will definitely require the SoC device match logic and an additional PRUSS disable quirk in the ti-sysc bus driver. regards Suman [1] https://patchwork.kernel.org/cover/11404569/ Roger Quadros (1): dt-bindings: bus: ti-sysc: Add support for PRUSS SYSC type Suman Anna (4): bus: ti-sysc: Add support for PRUSS SYSC type ARM: dts: AM33xx-l4: Update PRUSS interconnect target-module node ARM: dts: AM4372: Add the PRU-ICSS interconnect target-module node ARM: dts: dra7: Add PRU-ICSS interconnect target-module nodes .../devicetree/bindings/bus/ti-sysc.txt | 1 + arch/arm/boot/dts/am33xx-l4.dtsi | 21 ++++++-- arch/arm/boot/dts/am4372.dtsi | 22 ++++++++ arch/arm/boot/dts/am57-pruss.dtsi | 50 +++++++++++++++++++ arch/arm/boot/dts/am5718.dtsi | 1 + arch/arm/boot/dts/am5728.dtsi | 1 + arch/arm/boot/dts/am5748.dtsi | 1 + arch/arm/boot/dts/dra7.dtsi | 2 +- drivers/bus/ti-sysc.c | 27 ++++++++++ include/dt-bindings/bus/ti-sysc.h | 4 ++ include/linux/platform_data/ti-sysc.h | 2 + 11 files changed, 128 insertions(+), 4 deletions(-) create mode 100644 arch/arm/boot/dts/am57-pruss.dtsi -- 2.23.0
