The phy-gmii-sel can be only autoselacted in Kconfig and now the pretty complex Kconfig dependencies are defined for phy-gmii-sel driver, which also need to be updated every time phy-gmii-sel is re-used for any new networking driver. Simplify Kconfig definotion for phy-gmii-sel PHY driver - drop all depndencies and from networking drivers and rely on using 'imply imply PHY_TI_GMII_SEL' in Kconfig definotions for networking drivers instead. Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx> --- drivers/net/ethernet/ti/Kconfig | 1 + drivers/phy/ti/Kconfig | 3 --- 2 files changed, 1 insertion(+), 3 deletions(-) diff --git a/drivers/net/ethernet/ti/Kconfig b/drivers/net/ethernet/ti/Kconfig index bf98e0fa7d8b..8a6ca16eee3b 100644 --- a/drivers/net/ethernet/ti/Kconfig +++ b/drivers/net/ethernet/ti/Kconfig @@ -53,6 +53,7 @@ config TI_CPSW select MFD_SYSCON select PAGE_POOL select REGMAP + imply PHY_TI_GMII_SEL ---help--- This driver supports TI's CPSW Ethernet Switch. diff --git a/drivers/phy/ti/Kconfig b/drivers/phy/ti/Kconfig index 6dbe9d0b9ff3..15a3bcf32308 100644 --- a/drivers/phy/ti/Kconfig +++ b/drivers/phy/ti/Kconfig @@ -106,11 +106,8 @@ config TWL4030_USB config PHY_TI_GMII_SEL tristate - default y if TI_CPSW=y || TI_CPSW_SWITCHDEV=y - depends on TI_CPSW || TI_CPSW_SWITCHDEV || COMPILE_TEST select GENERIC_PHY select REGMAP - default m help This driver supports configuring of the TI CPSW Port mode depending on the Ethernet PHY connected to the CPSW Port. -- 2.17.1
