The description of "regulator-boot-on" was a little unclear, at least to me. Did this property mean that we should turn the regulator on at boot? Or perhaps it was intended only to be used for regulators where we couldn't read the state at bootup to indicate what state we should assume? The answer, it turns out, is both [1]. Let's document this. [1] https://lore.kernel.org/r/20190923181431.GU2036@xxxxxxxxxxxxx Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx> --- Changes in v2: - Don't mention Linux. Duh. Documentation/devicetree/bindings/regulator/regulator.yaml | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/regulator/regulator.yaml b/Documentation/devicetree/bindings/regulator/regulator.yaml index 02c3043ce419..92ff2e8ad572 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.yaml +++ b/Documentation/devicetree/bindings/regulator/regulator.yaml @@ -38,7 +38,12 @@ properties: type: boolean regulator-boot-on: - description: bootloader/firmware enabled regulator + description: bootloader/firmware enabled regulator. + It's expected that this regulator was left on by the bootloader. + If the bootloader didn't leave it on then OS should turn it on + at boot but shouldn't prevent it from being turned off later. + This property is intended to only be used for regulators where + software cannot read the state of the regulator. type: boolean regulator-allow-bypass: -- 2.23.0.444.g18eeb5a265-goog
