Hi Martin, On Mon, 2 Sep 2019 at 03:23, Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> wrote: > > Hi Anand, > > On Sun, Sep 1, 2019 at 3:58 PM Anand Moon <linux.amoon@xxxxxxxxx> wrote: > > > > Hi Martin, > > > > Thanks for your review comments. > > > > Their have been some revision changes in S905 Odroid Schematics. > > [0] https://dn.odroid.com/S905/Schematic/ > > > > Well I have make my changes based on old odroid-c2_rev0.2_20151218.pdf > > [...] > > > > > > according to the schematics there's both: > > > - VDDIO_AO3V3 > > > - VCC3V3 (which is turned on by VDDIO_AO3V3, see [0]) > > > > > > > From the schematics it seams same. > > > > VDDIO_AO3V3---DMG340LSQN4 (Q4)---VCC3V3 > yes, they are the same signal. the only difference is that VCC3V3 is > turned on later in the power-up sequence > > > But this name change was done to link TFLASH_VDD_EN to TFLASH_VDD for eMMC > > > > VDDIO_AO3V3-----TFLASH_VDD using TFLASH_VDD_EN gpio pin. > > > > Well I have tested this changes on eMMC module. > I cannot see any of the TFLASH_* regulators being linked to eMMC (they > are only linked to the SD card slot, I also checked > odroid-c2_rev0.2_20151218.pdf and odroid-c2_rev0.2_20171114.pdf). > which page of the odroid-c2_rev0.2_20151218.pdf schematics shows how > TFLASH_VDD is linked to eMMC? > > please note that I don't have an Odroid-C2 board myself (so I cannot > test any of this). > > > Martin Thanks I will double check again and re-post then with correction again. Best Regards -Anand
