From: Christian Mauderer <oss@xxxxxxxxxxxxx>
This patch adds the binding documentation for a simple SPI based LED
controller which use only one byte for setting the brightness.
Signed-off-by: Christian Mauderer <oss@xxxxxxxxxxxxx>
---
Changes compared to v3:
- rename binding to ubnt,acb-spi-led
- rewrite description to fit the new binding
- remove off-value and max-value - now determined depending on the compatible
string
- add 'default-state'
Changes compared to v2:
- None
Changes compared to v1:
- rename ubnt-spi to leds-spi-byte
- rename "ubnt-spi,off_bright" and "ubnt-spi,max_bright" to
"leds-spi-byte,off-value" and "leds-spi-byte,max-value" and mark them required
- rename led-controller node to "led-controller"
- extend description
- remove SPI controller
- use "white:status" for the example label
.../bindings/leds/leds-spi-byte.txt | 44 +++++++++++++++++++
1 file changed, 44 insertions(+)
create mode 100644 Documentation/devicetree/bindings/leds/leds-spi-byte.txt
diff --git a/Documentation/devicetree/bindings/leds/leds-spi-byte.txt b/Documentation/devicetree/bindings/leds/leds-spi-byte.txt
new file mode 100644
index 000000000000..28b6b2d9091e
--- /dev/null
+++ b/Documentation/devicetree/bindings/leds/leds-spi-byte.txt
@@ -0,0 +1,44 @@
+* Single Byte SPI LED Device Driver.
+
+The driver can be used for controllers with a very simple SPI protocol:
+- one LED is controlled by a single byte on MOSI
+- the value of the byte gives the brightness between two values (lowest to
+ highest)
+- no return value is necessary (no MISO signal)
+
+The value for lowest and highest brightness is dependent on the device and
+therefore on the compatible string.
+
+Depending on the compatible string some special functions (like hardware
+accelerated blinking) might can be supported too.
+
+The driver currently only supports one LED. The properties of the LED are
+configured in a sub-node in the device node.
+
+Required properties:
+- compatible: should be one of
+ * "ubnt,acb-spi-led" microcontroller (SONiX 8F26E611LA) based device
+ used for example in Ubiquiti airCube ISP
+
+Property rules described in Documentation/devicetree/bindings/spi/spi-bus.txt
+apply.
+
+LED sub-node properties:
+- label:
+ see Documentation/devicetree/bindings/leds/common.txt
+- default-state:
+ see Documentation/devicetree/bindings/leds/common.txt
+ Only "on" and "off" are supported.
+
+Example:
+
+led-controller@0 {
+ compatible = "ubnt,acb-spi-led";
+ reg = <0>;
+ spi-max-frequency = <100000>;
+
+ led {
+ label = "white:status";
+ default-state = "on";
+ };
+};
--
2.21.0
