Hi Rob,
Sorry to bother you again.
Can I describe usb-connector in usb node like this?
usb2: usb@11200000 {
compatible = "mediatek,mt2701-musb";
"mediatek,mtk-musb";
reg = <0 0x11200000 0 0x1000>;
...
usb_connector: musb_connector {
compatible = "usb-b-connector";
label = "micro-USB";
type = "micro";
extcon = <&extcon_usb>;
vbus-supply = <&usb_vbus>;
};
};
Regards,
Min.
On Fri, 2019-01-25 at 10:07 +0800, Min Guo wrote:
> Hi Bin,
>
> Thanks for your help.
>
> Hi Rob,
>
> I find that Samsung describes the usb-connector attribute in DTS, and
> uses a private driver.
> And try to write DTS as following:
>
> usb-connector node:
> musb_con: musb_connector{
> compatible = "linux,extcon-usb-gpio","usb-b-connector";
> lable = "micro-USB";
> type = "micro";
> id-gpio = <&pio 44 GPIO_ACTIVE_HIGH>
> vbus-supply = <&usb_vbus>;
> port {
> usb_to_connector: endpoint {
> remote-endpoint = <&connector_to_usb>;
> };
> };
> };
>
> usb node:
> &usb2{
> status = "okay";
> port {
> connector_to_usb: endpoint {
> remote-endpoint = <&usb_to_connector>;
> };
> };
> }
>
> Can I describe usb-connector like this? Or can you give me some advices?
>
> Regards,
> Min.
>
> On Tue, 2019-01-22 at 08:33 -0600, Bin Liu wrote:
> > Hi Min,
> >
> > On Tue, Jan 22, 2019 at 05:36:13PM +0800, Min Guo wrote:
> > > Hi Bin,
> > >
> > > Sorry to bother you again, I encounter a problem about the extcon
> > > property.
> > >
> > > I don't find a common driver describing the usb-connector. Is
> > > there any driver that I can refer to, specially the way to switch MUSB
> > > controller between host and device mode?
> > > If it needs to implement by myself, is it possible to emulate an
> > > usb-connector driver by extcon-usb-gpio, and also use the notifier
> > > mechanism or can you give me some advices?
> >
> > I am afraid I am unable to help you on this. I wasn't really pay
> > attention when usb-connector was introduced and not sure how it can
> > replace extcon. Now after read usb-connector.txt, it seems the binding
> > only defines a/b/c-connector, but not ab-connector, and there is no
> > enough information (at least for me) explaining how VBUS and ID fix into
> > this usb-connector binding.
> >
> > Maybe Rob can provide some hint.
> >
> > Regards,
> > -Bin.
>
