Hi Bin,
Thanks for your help.
Hi Rob,
I find that Samsung describes the usb-connector attribute in DTS, and
uses a private driver.
And try to write DTS as following:
usb-connector node:
musb_con: musb_connector{
compatible = "linux,extcon-usb-gpio","usb-b-connector";
lable = "micro-USB";
type = "micro";
id-gpio = <&pio 44 GPIO_ACTIVE_HIGH>
vbus-supply = <&usb_vbus>;
port {
usb_to_connector: endpoint {
remote-endpoint = <&connector_to_usb>;
};
};
};
usb node:
&usb2{
status = "okay";
port {
connector_to_usb: endpoint {
remote-endpoint = <&usb_to_connector>;
};
};
}
Can I describe usb-connector like this? Or can you give me some advices?
Regards,
Min.
On Tue, 2019-01-22 at 08:33 -0600, Bin Liu wrote:
> Hi Min,
>
> On Tue, Jan 22, 2019 at 05:36:13PM +0800, Min Guo wrote:
> > Hi Bin,
> >
> > Sorry to bother you again, I encounter a problem about the extcon
> > property.
> >
> > I don't find a common driver describing the usb-connector. Is
> > there any driver that I can refer to, specially the way to switch MUSB
> > controller between host and device mode?
> > If it needs to implement by myself, is it possible to emulate an
> > usb-connector driver by extcon-usb-gpio, and also use the notifier
> > mechanism or can you give me some advices?
>
> I am afraid I am unable to help you on this. I wasn't really pay
> attention when usb-connector was introduced and not sure how it can
> replace extcon. Now after read usb-connector.txt, it seems the binding
> only defines a/b/c-connector, but not ab-connector, and there is no
> enough information (at least for me) explaining how VBUS and ID fix into
> this usb-connector binding.
>
> Maybe Rob can provide some hint.
>
> Regards,
> -Bin.
