Hi Joakim,
On Fri, Oct 19, 2018 at 6:43 AM Joakim Zhang <qiangqing.zhang@xxxxxxx> wrote:
>
> From: Dong Aisheng <aisheng.dong@xxxxxxx>
>
> CAN transceiver is different on RevA and RevB board.
> It's active high on RevA while active low on Rev B.
>
> Signed-off-by: Dong Aisheng <aisheng.dong@xxxxxxx>
> Signed-off-by: Joakim Zhang <qiangqing.zhang@xxxxxxx>
> ---
> arch/arm/boot/dts/imx6sx-sdb.dts | 5 ++++
> arch/arm/boot/dts/imx6sx-sdb.dtsi | 42 +++++++++++++++++++++++++++++++
> 2 files changed, 47 insertions(+)
>
> diff --git a/arch/arm/boot/dts/imx6sx-sdb.dts b/arch/arm/boot/dts/imx6sx-sdb.dts
> index 6dd9bebfe027..092b8de142a8 100644
> --- a/arch/arm/boot/dts/imx6sx-sdb.dts
> +++ b/arch/arm/boot/dts/imx6sx-sdb.dts
> @@ -10,6 +10,11 @@
>
> / {
> model = "Freescale i.MX6 SoloX SDB RevB Board";
> +
> + /* Transceiver EN/STBY is active low on RevB board */
> + reg_can_stby: regulator-can-stby {
> + gpio = <&gpio4 27 GPIO_ACTIVE_LOW>;
Don't we need a gpio = <&gpio4 27 GPIO_ACTIVE_HIGH>; and also a
"enable-active-high" entries in the imx6sx-sdb-reva.dts?
