Input to qcom,sd-lines should be between 0 and 3 instead of
1 to 4 as 0 corresponds to BIT(0) which is MI2S_SD0 line.
Bit 1 to 3 corresponds to SD1 to SD3 lines respectively.
Updated documentation for the same.
Signed-off-by: Rohit kumar <rohitkr@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/sound/qcom,q6afe.txt | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/Documentation/devicetree/bindings/sound/qcom,q6afe.txt b/Documentation/devicetree/bindings/sound/qcom,q6afe.txt
index a817940..d74888b 100644
--- a/Documentation/devicetree/bindings/sound/qcom,q6afe.txt
+++ b/Documentation/devicetree/bindings/sound/qcom,q6afe.txt
@@ -49,7 +49,7 @@ configuration of each dai. Must contain the following properties.
Usage: required for mi2s interface
Value type: <prop-encoded-array>
Definition: Must be list of serial data lines used by this dai.
- should be one or more of the 1-4 sd lines.
+ should be one or more of the 0-3 sd lines.
- qcom,tdm-sync-mode:
Usage: required for tdm interface
@@ -137,42 +137,42 @@ q6afe@4 {
prim-mi2s-rx@16 {
reg = <16>;
- qcom,sd-lines = <1 3>;
+ qcom,sd-lines = <0 2>;
};
prim-mi2s-tx@17 {
reg = <17>;
- qcom,sd-lines = <2>;
+ qcom,sd-lines = <1>;
};
sec-mi2s-rx@18 {
reg = <18>;
- qcom,sd-lines = <1 4>;
+ qcom,sd-lines = <0 3>;
};
sec-mi2s-tx@19 {
reg = <19>;
- qcom,sd-lines = <2>;
+ qcom,sd-lines = <1>;
};
tert-mi2s-rx@20 {
reg = <20>;
- qcom,sd-lines = <2 4>;
+ qcom,sd-lines = <1 3>;
};
tert-mi2s-tx@21 {
reg = <21>;
- qcom,sd-lines = <1>;
+ qcom,sd-lines = <0>;
};
quat-mi2s-rx@22 {
reg = <22>;
- qcom,sd-lines = <1>;
+ qcom,sd-lines = <0>;
};
quat-mi2s-tx@23 {
reg = <23>;
- qcom,sd-lines = <2>;
+ qcom,sd-lines = <1>;
};
};
};
--
Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc.,
is a member of Code Aurora Forum, a Linux Foundation Collaborative Project.
