On Thu, Aug 16, 2018 at 3:17 AM Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> wrote: > > Ping? > > On Wed, Aug 01, 2018 at 02:16:27PM +0300, Sakari Ailus wrote: > > Hi Rob, > > > > Thanks for the review. > > > > On Tue, Jul 31, 2018 at 03:32:10PM -0600, Rob Herring wrote: > > > On Mon, Jul 23, 2018 at 04:46:50PM +0300, Sakari Ailus wrote: > > > > Allow specifying the bus type explicitly for MIPI D-PHY, parallel and > > > > Bt.656 busses. This is useful for devices that can make use of different > > > > bus types. There are CSI-2 transmitters and receivers but the PHY > > > > selection needs to be made between C-PHY and D-PHY; many devices also > > > > support parallel and Bt.656 interfaces but the means to pass that > > > > information to software wasn't there. > > > > > > > > Autodetection (value 0) is removed as an option as the property could be > > > > simply omitted in that case. > > > > > > Presumably there are users, so you can't remove it. But documenting > > > behavior when absent would be good. > > > > Well, it's effectively the same as having no such property at all: the type > > is not specified. Generally there are two possibilities: the hardware > > supports just a single bus or it supports more than one. If there's just > > one, the type can be known by the driver. In that case there's no use for > > autodetection. > > > > The second case is a bit more complicated: the bus type detection is solely > > based on properties available in the endpoint, and I think that may have > > been feasible approach when there were just parallel and Bt.656 busses that > > were supported, but with the additional busses, the V4L2 fwnode framework > > may no longer guess the bus in any meaningful way from the available > > properties. I'd think the only known-good option here is to specify the > > type explicitly in that case: there's no room for guessing. (This patchset > > makes it possible for drivers to explicitly define the bus type, but the > > autodetection support is maintained for backwards compatibility.) > > > > One of the existing issues is that there are combined parallel/Bt.656 > > receivers that need to know the type of the bus. This is based on the > > existence parallel interface only properties: if any of these exist, then > > the interface is parallel, otherwise it is Bt.656. The DT bindings for the > > same devices also define the defaults for the parallel interface. This > > leaves the end result ambiguous: is it the parallel interface with the > > default configuration or is it Bt.656? > > > > There will likely be similar issues for CSI-2 D-PHY and CSI-2 C-PHY. The > > question there would be: is this CSI-2 C-PHY or CSI-2 D-PHY with default > > clock lane configuration? > > > > In either case the autodetection option for the bus type provides no useful > > information. If it exists in DT source, that's fine, there's just no use > > for it. > > > > Let me know if you still think it should be maintained in binding > > documentation. > > If you prefer to keep it, I'd propose to mark it as deprecated or something > as it provides no information to software. Looks like there's only one user in tree: arch/arm/boot/dts/omap3-n900.dts: bus-type = <3>; /* CCP2 */ arch/arm/boot/dts/omap3-n900.dts: bus-type = <3>; /* CCP2 */ So I guess removing is okay. Rob
