Allow specifying the bus type explicitly for MIPI D-PHY, parallel and Bt.656 busses. This is useful for devices that can make use of different bus types. There are CSI-2 transmitters and receivers but the PHY selection needs to be made between C-PHY and D-PHY; many devices also support parallel and Bt.656 interfaces but the means to pass that information to software wasn't there. Autodetection (value 0) is removed as an option as the property could be simply omitted in that case. Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/media/video-interfaces.txt | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/media/video-interfaces.txt b/Documentation/devicetree/bindings/media/video-interfaces.txt index baf9d9756b3c..f884ada0bffc 100644 --- a/Documentation/devicetree/bindings/media/video-interfaces.txt +++ b/Documentation/devicetree/bindings/media/video-interfaces.txt @@ -100,10 +100,12 @@ Optional endpoint properties slave device (data source) by the master device (data sink). In the master mode the data source device is also the source of the synchronization signals. - bus-type: data bus type. Possible values are: - 0 - autodetect based on other properties (MIPI CSI-2 D-PHY, parallel or Bt656) 1 - MIPI CSI-2 C-PHY 2 - MIPI CSI1 3 - CCP2 + 4 - MIPI CSI-2 D-PHY + 5 - Parallel + 6 - Bt.656 - bus-width: number of data lines actively used, valid for the parallel busses. - data-shift: on the parallel data busses, if bus-width is used to specify the number of data lines, data-shift can be used to specify which data lines are -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
