[PATCH 12/12] ARM64: dts: marvell: use reworked NAND controller driver on Armada 8K

[Miquel Raynal <miquel.raynal@xxxxxxxxxxxxxxxxxx>]

Use the new bindings of the reworked Marvell NAND controller driver.
Also adapt the nand controller node organization to distinguish which
property is relevant for the controller, and which one is NAND chip
specific. Expose the partitions as a subnode of the NAND chip.

Remove the 'marvell,nand-enable-arbiter' property, not needed anymore as
the driver activates the arbiter by default for all boards (either
needed or harmless).

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/marvell/armada-8040-db.dts     | 46 +++++++++++++---------
 .../arm64/boot/dts/marvell/armada-cp110-slave.dtsi | 10 ++---
 2 files changed, 32 insertions(+), 24 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
index b1f6cccc5081..c25ac3fa9aec 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
@@ -272,27 +272,35 @@
  * Proper NAND usage will require DPR-76 to be in position 1-2, which disables
  * MDIO signal of CP1.
  */
-&cps_nand {
-	num-cs = <1>;
+&cps_nand_controller {
 	pinctrl-0 = <&nand_pins>, <&nand_rb>;
 	pinctrl-names = "default";
-	nand-ecc-strength = <4>;
-	nand-ecc-step-size = <512>;
-	marvell,nand-enable-arbiter;
-	marvell,system-controller = <&cps_syscon0>;
-	nand-on-flash-bbt;
-
-	partition@0 {
-		label = "U-Boot";
-		reg = <0 0x200000>;
-	};
-	partition@200000 {
-		label = "Linux";
-		reg = <0x200000 0xe00000>;
-	};
-	partition@1000000 {
-		label = "Filesystem";
-		reg = <0x1000000 0x3f000000>;
+
+	nand@0 {
+		reg = <0>;
+		marvell,rb = <0>;
+		nand-on-flash-bbt;
+		nand-ecc-strength = <4>;
+		nand-ecc-step-size = <512>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition@0 {
+				label = "U-Boot";
+				reg = <0 0x200000>;
+			};
+			partition@200000 {
+				label = "Linux";
+				reg = <0x200000 0xe00000>;
+			};
+			partition@1000000 {
+				label = "Filesystem";
+				reg = <0x1000000 0x3f000000>;
+			};
+		};
 	};
 };
 
diff --git a/arch/arm64/boot/dts/marvell/armada-cp110-slave.dtsi b/arch/arm64/boot/dts/marvell/armada-cp110-slave.dtsi
index cb1fb49ccf81..8610163bb1a4 100644
--- a/arch/arm64/boot/dts/marvell/armada-cp110-slave.dtsi
+++ b/arch/arm64/boot/dts/marvell/armada-cp110-slave.dtsi
@@ -310,20 +310,20 @@
 				status = "disabled";
 			};
 
-			cps_nand: nand@720000 {
+			cps_nand_controller: nand@720000 {
 				/*
 				 * Due to the limiation of the pin available
 				 * this controller is only usable on the CPM
 				 * for A7K and on the CPS for A8K.
 				 */
-				compatible = "marvell,armada370-nand",
-					     "marvell,armada-8k-nand";
+				compatible = "marvell,armada-8k-nand-controller",
+					     "marvell,armada370-nand-controller";
 				reg = <0x720000 0x54>;
 				#address-cells = <1>;
-				#size-cells = <1>;
+				#size-cells = <0>;
 				interrupts = <ICU_GRP_NSR 115 IRQ_TYPE_LEVEL_HIGH>;
 				clocks = <&cps_clk 1 2>;
-				marvell,system-controller = <&cpm_syscon0>;
+				marvell,system-controller = <&cps_syscon0>;
 				status = "disabled";
 			};
 
-- 
2.11.0

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html