This is a continuation of patch 4/5/6 from my previous series "gpio: mcp23s08: add support for mcp23018" The other patches from that series having already been applied. Hopefully I've address all of Linus's concerns. Wasn't too sure on how to handle the depcrated property documentation. Changes from v2: - Use standard 'drive-open-drain' for irq output configuration - deprecate 'microchip,irq-active-high' property and extract the irq polarity from the 'interrupts' property. - 'microchip,irq-active-high' property is now ignored except for a warning if the property exists. This is probably safe as the 'interrupts' property is most likely setup correctly. Phil Reid (5): pinctrl: mcp23s08: remove hard coded irq polarity in irq_setup dt-bindings: pinctrl: mcp23s08: add documentation for drive-open-drain pinctrl: mcp23s08: add open drain configuration for irq output pinctrl: mcp23s08: configure irq polarity using irq data dt-bindings: pinctrl: deprecate 'microchip,irq-active-high' property .../bindings/pinctrl/pinctrl-mcp23s08.txt | 6 +++-- drivers/pinctrl/pinctrl-mcp23s08.c | 28 ++++++++++++---------- 2 files changed, 20 insertions(+), 14 deletions(-) -- 1.8.3.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
