Signed-off-by: Tim Harvey <tharvey@xxxxxxxxxxxxx>
---
.../devicetree/bindings/media/i2c/tda1997x.txt | 159 +++++++++++++++++++++
1 file changed, 159 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/i2c/tda1997x.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/tda1997x.txt b/Documentation/devicetree/bindings/media/i2c/tda1997x.txt
new file mode 100644
index 0000000..8330733
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/tda1997x.txt
@@ -0,0 +1,159 @@
+Device-Tree bindings for the NXP TDA1997x HDMI receiver
+
+The TDA19971/73 are HDMI video receivers.
+
+The TDA19971 Video port output pins can be used as follows:
+ - RGB 8bit per color (24 bits total): R[11:4] B[11:4] G[11:4]
+ - YUV444 8bit per color (24 bits total): Y[11:4] Cr[11:4] Cb[11:4]
+ - YUV422 semi-planar 8bit per component (16 bits total): Y[11:4] CbCr[11:4]
+ - YUV422 semi-planar 10bit per component (20 bits total): Y[11:2] CbCr[11:2]
+ - YUV422 semi-planar 12bit per component (24 bits total): - Y[11:0] CbCr[11:0]
+ - YUV422 BT656 8bit per component (8 bits total): YCbCr[11:4] (2-cycles)
+ - YUV422 BT656 10bit per component (10 bits total): YCbCr[11:2] (2-cycles)
+ - YUV422 BT656 12bit per component (12 bits total): YCbCr[11:0] (2-cycles)
+
+The TDA19973 Video port output pins can be used as follows:
+ - RGB 12bit per color (36 bits total): R[11:0] B[11:0] G[11:0]
+ - YUV444 12bit per color (36 bits total): Y[11:0] Cb[11:0] Cr[11:0]
+ - YUV422 semi-planar 12bit per component (24 bits total): Y[11:0] CbCr[11:0]
+ - YUV422 BT656 12bit per component (12 bits total): YCbCr[11:0] (2-cycles)
+
+The Video port output pins are mapped via 4-bit 'pin groups' allowing
+for a variety fo connection possibilities including swapping pin order within
+pin groups. The video_portcfg device-tree property consists of register mapping
+pairs which map a chip-specific VP output register to a 4-bit pin group. If
+the pin group needs to be bit-swapped you can use the *_S pin-group defines.
+
+Required Properties:
+ - compatible :
+ - "nxp,tda19971" for the TDA19971
+ - "nxp,tda19973" for the TDA19973
+ - reg : I2C slave address
+ - interrupts : The interrupt number
+ - DOVDD-supply : Digital I/O supply
+ - DVDD-supply : Digital Core supply
+ - AVDD-supply : Analog supply
+ - vidout_portcfg : array of pairs mapping VP output pins to pin groups
+
+Optional Properties:
+ - max-pixel-rate : Maximum pixel rate supported by the SoC (MP/sec)
+ - audio-port : parameters defining audio output port connection
+
+Optional Endpoint Properties:
+ The following three properties are defined in video-interfaces.txt and
+ are valid for source endpoints only:
+ - hsync-active: Horizontal synchronization polarity. Defaults to active high.
+ - vsync-active: Vertical synchronization polarity. Defaults to active high.
+ - data-active: Data polarity. Defaults to active high.
+
+The Audio output port consists of A_CLK, A_WS, AP0, AP1, AP2, and AP3 pins
+and can support up to 8-chanenl audio using the following audio bus DAI formats:
+ - I2S16
+ - I2S32
+ - SPDIF
+ - OBA (One-Bit-Audio)
+ - I2S16_HBR_STRAIGHT (High Bitrate straight through)
+ - I2S16_HBR_DEMUX (High Bitrate demuxed)
+ - I2S32_HBR_DEMUX (High Bitrate demuxed)
+ - DST (Direct Stream Transfer)
+
+Audio samples can be output in either SPDIF or I2S bus formats.
+In I2S mode, the TDF1997X is the master with 16bit or 32bit words.
+The audio port output is configured by three parameters: DAI format, layout
+and clock scaler.
+
+Each DAI format has two pin layouts shown by the following table:
+ | SPDIF | SPDIF | I2S | I2S | HBR demux
+ | Layout0 | Layout1 | Layout0 | Layout1 | SPDIF | I2S
+ ------+---------+---------+---------+---------+------------+------------
+ A_WS | WS | WS | WS | WS | WS | WS
+ AP3 | | SPDIF3 | | SD3 | SPDIF[x+3] | SD[x+3]
+ AP2 | | SPDIF2 | | SD2 | SPDIF[x+2] | SD[x+2]
+ AP1 | | SPDIF1 | | SD1 | SPDIF[x+1] | SD[x+1]
+ AP0 | SPDIF | SPDIF0 | SD | SD0 | SPDIF[x] | SD[x]
+ A_CLK | (32*Fs) | (32*Fs) |(32*Fs) | (32*Fs) | (32*Fs) | (32*Fs)
+ | (64*Fs) | (64*Fs) |(64*Fs) | (64*Fs) | (64*Fs) | (64*Fs)
+
+Freq(Sysclk) = 2*freq(Aclk)
+
+Examples:
+ - VP[15:0] connected to IMX6 CSI_DATA[19:4] for 16bit YUV422
+ 16bit I2S layout0 with a 128*fs clock (A_WS, AP0, A_CLK pins)
+ hdmi_receiver@48 {
+ compatible = "nxp,tda19971";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_tda1997x>;
+ reg = <0x48>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
+ DOVDD-supply = <®_3p3v>;
+ AVDD-supply = <®_1p8v>;
+ DVDD-supply = <®_1p8v>;
+ /* audio output format */
+ audio-port = < TDA1997X_I2S16
+ TDA1997X_LAYOUT0
+ TDA1997X_ACLK_128FS >;
+ /*
+ * The 8bpp YUV422 semi-planar mode outputs CbCr[11:4]
+ * and Y[11:4] across 16bits in the same pixclk cycle.
+ */
+ vidout_portcfg =
+ /* Y[11:8]<->VP[15:12]<->CSI_DATA[19:16] */
+ < TDA1997X_VP24_V15_12 TDA1997X_G_Y_11_8 >,
+ /* Y[7:4]<->VP[11:08]<->CSI_DATA[15:12] */
+ < TDA1997X_VP24_V11_08 TDA1997X_G_Y_7_4 >,
+ /* CbCc[11:8]<->VP[07:04]<->CSI_DATA[11:8] */
+ < TDA1997X_VP24_V07_04 TDA1997X_R_CR_CBCR_11_8 >,
+ /* CbCr[7:4]<->VP[03:00]<->CSI_DATA[7:4] */
+ < TDA1997X_VP24_V03_00 TDA1997X_R_CR_CBCR_7_4 >;
+ max-pixel-rate = <180>; /* IMX6 CSI max pixel rate 180MP/sec */
+
+ port@0 {
+ reg = <0>;
+ };
+ port@1 {
+ reg = <1>;
+ hdmi_in: endpoint {
+ remote-endpoint = <&ccdc_in>;
+ };
+ };
+ };
+ - VP[15:8] connected to IMX6 CSI_DATA[19:12] for 8bit BT656
+ 16bit I2S layout0 with a 128*fs clock (A_WS, AP0, A_CLK pins)
+ hdmi_receiver@48 {
+ compatible = "nxp,tda19971";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_tda1997x>;
+ reg = <0x48>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
+ DOVDD-supply = <®_3p3v>;
+ AVDD-supply = <®_1p8v>;
+ DVDD-supply = <®_1p8v>;
+ /* audio output format */
+ #sound-dai-cells = <0>;
+ audio-port = < TDA1997X_I2S16
+ TDA1997X_LAYOUT0
+ TDA1997X_ACLK_128FS >;
+ /*
+ * The 8bpp BT656 mode outputs YCbCr[11:4] across 8bits over
+ * 2 pixclk cycles.
+ */
+ vidout_portcfg =
+ /* YCbCr[11:8]<->VP[15:12]<->CSI_DATA[19:16] */
+ < TDA1997X_VP24_V15_12 TDA1997X_R_CR_CBCR_11_8 >,
+ /* YCbCr[7:4]<->VP[11:08]<->CSI_DATA[15:12] */
+ < TDA1997X_VP24_V11_08 TDA1997X_R_CR_CBCR_7_4 >,
+ max-pixel-rate = <180>; /* IMX6 CSI max pixel rate 180MP/sec */
+
+ port@0 {
+ reg = <0>;
+ };
+ port@1 {
+ reg = <1>;
+ hdmi_in: endpoint {
+ remote-endpoint = <&ccdc_in>;
+ };
+ };
+ };
+
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
