The second cell in a gpio reference is used to pass GPIO_ACTIVE_LOW or GPIO_ACTIVE_HIGH. The gpio device can also be used as irq controller and a reference can contain the IRQ_TYPE_* values in the second cell. Signed-off-by: Uwe Kleine-König <uwe@xxxxxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/gpio/gpio_atmel.txt | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/gpio/gpio_atmel.txt b/Documentation/devicetree/bindings/gpio/gpio_atmel.txt index 85f8c0d084fa..b53fe3bce270 100644 --- a/Documentation/devicetree/bindings/gpio/gpio_atmel.txt +++ b/Documentation/devicetree/bindings/gpio/gpio_atmel.txt @@ -5,9 +5,16 @@ Required properties: - reg: Should contain GPIO controller registers location and length - interrupts: Should be the port interrupt shared by all the pins. - #gpio-cells: Should be two. The first cell is the pin number and - the second cell is used to specify optional parameters (currently - unused). + the second cell is used to specify optional parameters to declare if the GPIO + is active high or low. See gpio.txt. - gpio-controller: Marks the device node as a GPIO controller. +- interrupt-controller: Marks the device node as a GPIO controller. +- #interrupt-cells: Should be two. The first cell is the pin number and the + second cell is used to specify irq type flags: + 1 = low-to-high edge triggered. + 2 = high-to-low edge triggered. + 4 = active high level-sensitive. + 8 = active low level-sensitive. optional properties: - #gpio-lines: Number of gpio if absent 32. @@ -21,5 +28,7 @@ Example: #gpio-cells = <2>; gpio-controller; #gpio-lines = <19>; + interrupt-controller; + #interrupt-cells = <2>; }; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html