Hi Masahiro, On Thu, 23 Mar 2017 05:06:59 +0900 Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> wrote: > It took a couple months to update this series, but finally here is v2. > (v1: https://lkml.org/lkml/2016/11/26/144 ) > > This driver includes many problems. > > One of the biggest one is a bunch of hard-coded parameters. This IP > has many parameters that can be customized when a delivery RTL is > generated. However, this driver was upstreamed by Intel, with > Intel parameters hard-coded. Later, Altera added denali_dt.c to use > this driver for embedded boards, but they did not fix the code in > denali.c So, this driver has never worked. Even some DT bindings > actually turned out wrong. > > There are more problems: [1] The driver just retrieves the OOB area as-is > whereas the controller uses syndrome page layout. [2] Many NAND chip > specific parameters are hard-coded in the driver. [3] ONFi devices are > not working [4] It can not read Bad Block Marker > > This patch series intends to solve those problems. > > Since v1, here are more fixes/improvements: > - Fix raw/oob callbacks for syndrome page layout > - Implement setup_data_interface() callback > - Fix/implement more commands for ONFi devices > - Allow to skip the driver internal bounce buffer > - Support PIO in case DMA is not supported > - Switch from ->cmdfunc over to ->cmd_ctrl > > > Masahiro Yamada (53): > mtd: nand: allow to set only one of ECC size and ECC strength from DT > mtd: nand: use read_oob() instead of cmdfunc() for bad block check > mtd: nand: denali: remove unused CONFIG option and macros > mtd: nand: denali: remove redundant define of BANK(x) > mtd: nand: denali: remove more unused struct members > mtd: nand: denali: fix comment of denali_nand_info::flash_mem > mtd: nand: denali: consolidate INTR_STATUS__* and INTR_EN__* macros > mtd: nand: denali: introduce capability flag > mtd: nand: denali: use int where no reason to use fixed width variable > mtd: nand: denali: fix erased page checking > mtd: nand: denali: fix bitflips calculation in handle_ecc() > mtd: nand: denali: support HW_ECC_FIXUP capability > mtd: nand: denali_dt: enable HW_ECC_FIXUP for Altera SOCFPGA variant > mtd: nand: denali: support 64bit capable DMA engine > mtd: nand: denali_dt: remove dma-mask DT property > mtd: nand: denali_dt: use pdev instead of ofdev for platform_device > mtd: nand: denali: allow to override revision number > mtd: nand: denali: use nand_chip to hold frequently accessed data > mtd: nand: denali: call nand_set_flash_node() to set DT node > mtd: nand: denali: do not set mtd->name > mtd: nand: denali: move multi device fixup code to a helper function > mtd: nand: denali: simplify multi device fixup code > mtd: nand: denali: set DEVICES_CONNECTED 1 if not set > mtd: nand: denali: remove meaningless writes to read-only registers > mtd: nand: denali: remove unnecessary writes to ECC_CORRECTION > mtd: nand: denali: support 1024 byte ECC step size > mtd: nand: denali: avoid hard-coding ecc.strength and ecc.bytes > mtd: nand: denali: support "nand-ecc-strength" DT property > mtd: nand: denali: remove Toshiba and Hynix specific fixup code > mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants > mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS > mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc() > mtd: nand: denali: use BIT() and GENMASK() for register macros > mtd: nand: denali: remove unneeded find_valid_banks() > mtd: nand: denali: handle timing parameters by setup_data_interface() > mtd: nand: denali: remove meaningless pipeline read-ahead operation > mtd: nand: denali: rework interrupt handling > mtd: nand: denali: fix NAND_CMD_STATUS handling > mtd: nand: denali: fix NAND_CMD_PARAM handling > mtd: nand: do not check R/B# for CMD_READID in nand_command(_lp) > mtd: nand: do not check R/B# for CMD_SET_FEATURES in nand_command(_lp) > mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc > mtd: nand: denali: fix bank reset function > mtd: nand: denali: use interrupt instead of polling for bank reset > mtd: nand: denali: propagate page to helpers via function argument > mtd: nand: denali: merge struct nand_buf into struct denali_nand_info > mtd: nand: denali: use flag instead of register macro for direction > mtd: nand: denali: fix raw and oob accessors for syndrome page layout > mtd: nand: denali: support hardware-assisted erased page detection > mtd: nand: allocate aligned buffers if NAND_OWN_BUFFERS is unset > mtd: nand: denali: skip driver internal bounce buffer when possible > mtd: nand: denali: use non-managed kmalloc() for DMA buffer > mtd: nand: denali: enable bad block table scan Applied patch 1 to 9, 40 and 41. I'll see what else I can apply so that you don't have to re-post the remaining 42 patches, but I fear some of them won't apply correctly without patch 10 on which I had comments. Thanks, Boris -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
