Hi Boris, 2017-03-25 5:13 GMT+09:00 Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>: >> >> Masahiro Yamada (53): >> mtd: nand: allow to set only one of ECC size and ECC strength from DT >> mtd: nand: use read_oob() instead of cmdfunc() for bad block check >> mtd: nand: denali: remove unused CONFIG option and macros >> mtd: nand: denali: remove redundant define of BANK(x) >> mtd: nand: denali: remove more unused struct members >> mtd: nand: denali: fix comment of denali_nand_info::flash_mem >> mtd: nand: denali: consolidate INTR_STATUS__* and INTR_EN__* macros >> mtd: nand: denali: introduce capability flag >> mtd: nand: denali: use int where no reason to use fixed width variable >> mtd: nand: denali: fix erased page checking >> mtd: nand: denali: fix bitflips calculation in handle_ecc() >> mtd: nand: denali: support HW_ECC_FIXUP capability >> mtd: nand: denali_dt: enable HW_ECC_FIXUP for Altera SOCFPGA variant >> mtd: nand: denali: support 64bit capable DMA engine >> mtd: nand: denali_dt: remove dma-mask DT property >> mtd: nand: denali_dt: use pdev instead of ofdev for platform_device >> mtd: nand: denali: allow to override revision number >> mtd: nand: denali: use nand_chip to hold frequently accessed data >> mtd: nand: denali: call nand_set_flash_node() to set DT node >> mtd: nand: denali: do not set mtd->name >> mtd: nand: denali: move multi device fixup code to a helper function >> mtd: nand: denali: simplify multi device fixup code >> mtd: nand: denali: set DEVICES_CONNECTED 1 if not set >> mtd: nand: denali: remove meaningless writes to read-only registers >> mtd: nand: denali: remove unnecessary writes to ECC_CORRECTION >> mtd: nand: denali: support 1024 byte ECC step size >> mtd: nand: denali: avoid hard-coding ecc.strength and ecc.bytes >> mtd: nand: denali: support "nand-ecc-strength" DT property >> mtd: nand: denali: remove Toshiba and Hynix specific fixup code >> mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants >> mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS >> mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc() >> mtd: nand: denali: use BIT() and GENMASK() for register macros >> mtd: nand: denali: remove unneeded find_valid_banks() >> mtd: nand: denali: handle timing parameters by setup_data_interface() >> mtd: nand: denali: remove meaningless pipeline read-ahead operation >> mtd: nand: denali: rework interrupt handling >> mtd: nand: denali: fix NAND_CMD_STATUS handling >> mtd: nand: denali: fix NAND_CMD_PARAM handling >> mtd: nand: do not check R/B# for CMD_READID in nand_command(_lp) >> mtd: nand: do not check R/B# for CMD_SET_FEATURES in nand_command(_lp) >> mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc >> mtd: nand: denali: fix bank reset function >> mtd: nand: denali: use interrupt instead of polling for bank reset >> mtd: nand: denali: propagate page to helpers via function argument >> mtd: nand: denali: merge struct nand_buf into struct denali_nand_info >> mtd: nand: denali: use flag instead of register macro for direction >> mtd: nand: denali: fix raw and oob accessors for syndrome page layout >> mtd: nand: denali: support hardware-assisted erased page detection >> mtd: nand: allocate aligned buffers if NAND_OWN_BUFFERS is unset >> mtd: nand: denali: skip driver internal bounce buffer when possible >> mtd: nand: denali: use non-managed kmalloc() for DMA buffer >> mtd: nand: denali: enable bad block table scan > > Applied patch 1 to 9, 40 and 41. I'll see what else I can apply so that > you don't have to re-post the remaining 42 patches, but I fear some of > them won't apply correctly without patch 10 on which I had comments. Thanks! This will be very helpful when sending the next version. If you like, you can also apply the following 9 patches cleanly in this order. 18/53 mtd: nand: denali: use nand_chip to hold frequently accessed data 19/53 mtd: nand: denali: call nand_set_flash_node() to set DT node 20/53 mtd: nand: denali: do not set mtd->name 21/53 mtd: nand: denali: move multi device fixup code to a helper function 22/53 mtd: nand: denali: simplify multi device fixup code 23/53 mtd: nand: denali: set DEVICES_CONNECTED 1 if not set 24/53 mtd: nand: denali: remove meaningless writes to read-only registers 25/53 mtd: nand: denali: remove unnecessary writes to ECC_CORRECTION 36/53 mtd: nand: denali: remove meaningless pipeline read-ahead operation These are less controversial, and have no dependency on 10/53-17/53. 50/53 "mtd: nand: allocate aligned buffers if NAND_OWN_BUFFERS is unset" is a change to the NAND framework. (used as a pre-requisite for 51/53) Surely no dependency on the others, but If you wait more for comments from other developers, that's no problem. I will update the commented parts, and hopefully send v3 next week. Thanks! -- Best Regards Masahiro Yamada -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
