Re: [PATCH v2 2/2] can: spi: hi311x: Add Holt HI-311x CAN driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hello Akshay,

Am 17.03.2017 um 19:28 schrieb Akshay Bhat:
Hi Wolfgang,

On 03/17/2017 01:04 PM, Wolfgang Grandegger wrote:

Hm, that's unusual. Cable disconnected and then send a message:

$ grep /proc/interrupts; sleep 10; /proc/interrupts

should make things clear. But maybe it's a clever chip and it does stop
sending error messages if the error counter does not change any more.
After bus-off, the chip is quiet, of course. Should have a closer look
to the CAN standard.


The interrupt count does not increment after device reaches
tx-error-passive (with cable disconnected).

# while true; do grep -i hi3110 /proc/interrupts; sleep 10; done &
[1] 793
#
111:          0          0  gpio-mxc  12 Edge      hi3110
# candump -t d -e any,0:0,#FFFFFFF &
[2] 798
# cansend can0 123#
#
 (000.000000)  can0  20000004   [8]  00 08 00 00 00 00 60 00   ERRORFRAME
	controller-problem{tx-error-warning}
	error-counter-tx-rx{{96}{0}}
 (000.002122)  can0  20000004   [8]  00 20 00 00 00 00 80 00   ERRORFRAME
	controller-problem{tx-error-passive}
	error-counter-tx-rx{{128}{0}}
111:         10          0  gpio-mxc  12 Edge      hi3110
111:         10          0  gpio-mxc  12 Edge      hi3110
111:         10          0  gpio-mxc  12 Edge      hi3110

OK, then there is no good reason connecting the STAT interrupt pin.

Wolfgang.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux