> Thanks for the hint on the compatibility. I wonder if > Documentation/devicetree/bindings/net/dsa/marvell.txt should have some > notes added about switch device compatibility? It wasn't clear to me > that these would be compatible. Hi Tim This keeps coming up, so i plan on submitting a patch. I thought it would be obvious. The driver supports over 20 Marvell switches, yet only has two compatible strings. It is not too big a leap to figure out they must all be compatible, or there would be 20 compatible strings.... > What is the convention, if any, of the naming of the 'lan' ports (0 > based vs 1 based, eth vs lan)? Is it strictly up to the board vendor? > The board I'm supporting has a silkscreen that shows 'Port 1' through > 'Port 4' so I was leaning towards 1 based. I recommend following what the label on the housing says. If you don't have a housing, just a board, follow the silk screen, and hope the designer of the housing also follows the silk screen. Andrew -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
