On Tue, Mar 7, 2017 at 3:08 PM, Sebastian Reichel <sre@xxxxxxxxxx> wrote: > Hi Rob, > > On Tue, Mar 07, 2017 at 10:30:51AM -0600, Rob Herring wrote: >> On Sat, Mar 4, 2017 at 5:58 AM, Sebastian Reichel <sre@xxxxxxxxxx> wrote: >> > This adds a driver for the Nokia H4+ protocol, which is used >> > at least on the Nokia N9, N900 & N950. >> > >> > Signed-off-by: Sebastian Reichel <sre@xxxxxxxxxx> >> > --- >> > .../devicetree/bindings/net/nokia-bluetooth.txt | 51 ++ >> >> This should be separate and before the dts files. >> >> > drivers/bluetooth/Kconfig | 12 + >> > drivers/bluetooth/Makefile | 2 + >> > drivers/bluetooth/hci_nokia.c | 839 +++++++++++++++++++++ >> > 4 files changed, 904 insertions(+) >> > create mode 100644 Documentation/devicetree/bindings/net/nokia-bluetooth.txt >> > create mode 100644 drivers/bluetooth/hci_nokia.c >> > >> > diff --git a/Documentation/devicetree/bindings/net/nokia-bluetooth.txt b/Documentation/devicetree/bindings/net/nokia-bluetooth.txt >> > new file mode 100644 >> > index 000000000000..6c80a92f31e2 >> > --- /dev/null >> > +++ b/Documentation/devicetree/bindings/net/nokia-bluetooth.txt >> > @@ -0,0 +1,51 @@ >> > +Nokia Bluetooth Chips >> > +--------------------- >> > + >> > +Nokia phones often come with UART connected bluetooth chips from different >> > +vendors and modified device API. Those devices speak a protocol named H4+ >> > +by Nokia, which is similar to the H4 protocol from the Bluetooth standard. >> > +In addition to the H4 protocol it specifies two more UART status lines for >> > +wakeup of UART transceivers to improve power management and a few new packet >> > +types used to negotiate uart speed. >> > + >> > +Required properties: >> > + >> > + - compatible: should be one of the following: >> > + * "nokia,brcm,bcm2048" >> > + * "nokia,ti,wl1271-bluetooth" >> >> Drop the chip vendors' prefix here. I don't really want to start a >> pattern of 2 vendor prefixes. > > Right, I think we discussed this before, but I don't remember the > result. How about > > - compatible: should contain "nokia,h4p-bluetooth" as well as one of the following: > * "brcm,bcm2048-nokia" > * "ti,wl1271-blueooth-nokia" Sure, that's fine (other than the typo). > For the driver it should be enough to know "nokia,h4p-bluetooth" > actually. The device identifies itself in the negotiation reply. > >> > + - reset-gpios: GPIO specifier, used to reset the BT module >> >> Need to state active state. > > ok. Any suggestion about the wording? The BT chips use usually > active low reset pin. The driver handles all GPIOs as active > high with the DT binding translating this transparently. Just having "active low" in there is enough. Personally I find the GPIO translating confusing... Rob -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
