From: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
Add device tree bindings document for the GPIO driver of
Juniper's I2CS FPGA.
Signed-off-by: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
[Ported from Juniper kernel]
Signed-off-by: Pantelis Antoniou <pantelis.antoniou@xxxxxxxxxxxx>
---
.../devicetree/bindings/gpio/jnx,gpio-i2cs.txt | 43 ++++++++++++++++++++++
1 file changed, 43 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-i2cs.txt
diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-i2cs.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-i2cs.txt
new file mode 100644
index 0000000..835b7fb4
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-i2cs.txt
@@ -0,0 +1,43 @@
+Juniper I2CS FPGA GPIO presence block
+
+This is virtual gpio driver, that maps each bit of the I2CS FPGA to
+a gpio. It's used as a compatibility replacement for FRUs that use
+I2CS FPGA to report presence, control and report power status in
+the Juniper's driver infra that uses gpios. Compatible with any I2CS.
+
+Required properties:
+
+Required properties:
+- compatible: "jnx,gpio-i2cs"
+
+- reg:
+ Address on the I2C bus of the I2CS FPGA
+
+- gpio-controller: Marks the device node as a gpio controller.
+
+- interrupt-controller: Marks the device node as an interrupt
+ controller.
+
+- i2c-gpio-map: Map of "I2CS register" and "direction". The registers
+ are 8 bit wide, each bit of the register is mapped to either
+ input or output depending on the bits of the "direction". If
+ the bit in the direction is 1, then that bit from the I2CS
+ register is mapped to gpio input, otherwise to gpio output.
+
+- #gpio-cells : Should be two. The first cell is the pin number and
+ the second cell is used to specify the gpio polarity:
+ 0 = active high
+ 1 = active low
+
+Optional properties:
+
+Example:
+
+cb0_slave: i2c-slave@54 {
+ compatible = "jnx,gpio-i2cs";
+ reg = <0x54>;
+ #gpio-cells = <2>;
+ gpio-controller;
+ interrupt-controller;
+ i2c-gpio-map = <0x21 0xff>; /* power status (bit 6) */
+};
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
