On Tue, Sep 6, 2016 at 6:45 PM, Alexandre TORGUE <alexandre.torgue@xxxxxx> wrote: > This patch adds IRQ support to STM32 gpios. > > The EXTI controller has 16 lines dedicated to GPIOs. > EXTI line n can be connected to only line n of one of the GPIO ports, for > example EXTI0 can be connected to either PA0, or PB0, or PC0... > This port selection is done by specifying the port number into System > Config registers. > > Signed-off-by: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx> > Signed-off-by: Alexandre TORGUE <alexandre.torgue@xxxxxx> > +++ b/drivers/pinctrl/stm32/Kconfig > @@ -6,6 +6,8 @@ config PINCTRL_STM32 > select PINMUX > select GENERIC_PINCONF > select GPIOLIB > + select GPIOLIB_IRQCHIP But you're not really using GPIOLIB_IRQCHIP. You have a different, super-complex irqchip in use. So just don't select this. > + bank->gpio_chip.irqdomain = irq_domain_create_hierarchy(pctl->domain, > + 0, STM32_GPIO_IRQ_LINE, bank->fwnode, > + &stm32_gpio_domain_ops, bank); Don't use that irqdomain pointer inside the gpio_chip. Instead declare the irqdomain pointer inside struct stm32_gpio_bank or something like that. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
