Arnd,
> > > >
> > > > - all wilink family needs special init command for entering wspi mode.
> > > > extra clock cycles should be sent after the spi init command while the
> > > > cs pin is high.
> > > > - switch to controling the cs pin from the spi driver for achieveing the
> > > > above.
> > > > - the selected cs gpio is read from the spi device-tree node using the
> > > > cs-gpios field and setup as a gpio.
> > > > - See the example below for specifying the cs gpio using the cs-gpios
> entry
> > > > &spi0 {
> > > > ...
> > > > cs-gpios = <&gpio0 5 0>;
> > > > ...
> > > > wlcore: wlcore@0 {
> > > > compatible = "ti,wl1835";
> > > > ...
> > > > ...
> > > > };
> > > > };
> > > >
> > > > Signed-off-by: Eyal Reizer <eyalr@xxxxxx>
> > >
> > > I don't think this can work in general: not all SPI hosts uses GPIOs
> > > for controlling CS, so the logic can't work, and it's also a
> > > layering violation for the driver to look at the parent.
> > >
> > > I would suggest fixing this using a new API function from the SPI
> > > core, if we don't already have a generic way to do it.
> > >
> > Originally this is what I have done until I was pointed to the generic
> > cs-gpio mechanism in the SPI core.
> > It is a generic mechanism already in the SPI core driver.
> > See: Documentation/devicetree/bindings/spi/spi-bus.txt
>
> The cs-gpios property is documented as optional, it defines how you should
> list the gpios if CS is implemented using gpio, but not all hardware does it like
> this.
>
> > It is also part of the generic spi.h (include/Linux/spi/spi.h),
> > already part of " struct spi_device" So it seemed redundant adding
> > another mechanism for implementing the same.
> > Platform that interact with a wilink need to use it, and platforms
> > that don't have this capability will probably not interact with a wilink device
> using SPI.
>
> The cs_gpio field in spi_device belongs to the spi host controller, no other
> slave driver uses it.
>
> I wasn't asking for a duplication of this mechanism, but an interface to use it
> properly. Internally, the spi core uses the spi_set_cs() function to pick a CS.
> Find a way to use that rather than reimplementing it incorrectly.
>
Understood. As this special CS manipulation is unique to wspi (wilink spi) I think the
best option is to move this gpio allocation into wlcore_spi as a new device tree entry
used only by this driver.
If you agree I will submit a v3.
Best Regards,
Eyal
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
