On 14.03.2016 11:04, Chanwoo Choi wrote:
> This patch adds the MSHC2 (Mobile Storage Host Controller) Device Tree node for
> Exynos3250 SoC.
>
> Cc: Kukjin Kim <kgene@xxxxxxxxxx>
> Cc: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> Signed-off-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
> Reviewed-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> ---
> arch/arm/boot/dts/exynos3250-pinctrl.dtsi | 35 +++++++++++++++++++++++++++++++
> arch/arm/boot/dts/exynos3250.dtsi | 13 ++++++++++++
> 2 files changed, 48 insertions(+)
After looking at your other patch ("ARM: dts: Add initial pin
configuration for exynos3250-rinato") I have doubts. The Monk will be
affected.
Here you are configuring all the gpk2 GPIOS for EMMC2 mode. Then on
Rinato you are setting it back to default non-used state. However the
Monk board will remain with this new configuration... so you would have
to add initial-state also for Monk.
But how about doing opposite? Configure here the pins to unused state
and enable them only for Artik board?
What do you think?
Best regards,
Krzysztof
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
