On 2016년 03월 14일 15:22, Krzysztof Kozlowski wrote:
> On 14.03.2016 11:04, Chanwoo Choi wrote:
>> This patch adds the MSHC2 (Mobile Storage Host Controller) Device Tree node for
>> Exynos3250 SoC.
>>
>> Cc: Kukjin Kim <kgene@xxxxxxxxxx>
>> Cc: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
>> Signed-off-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
>> Reviewed-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
>> ---
>> arch/arm/boot/dts/exynos3250-pinctrl.dtsi | 35 +++++++++++++++++++++++++++++++
>> arch/arm/boot/dts/exynos3250.dtsi | 13 ++++++++++++
>> 2 files changed, 48 insertions(+)
>
>
> After looking at your other patch ("ARM: dts: Add initial pin
> configuration for exynos3250-rinato") I have doubts. The Monk will be
> affected.
You're right. On monk board, this line may be not stable.
>
> Here you are configuring all the gpk2 GPIOS for EMMC2 mode. Then on
> Rinato you are setting it back to default non-used state. However the
> Monk board will remain with this new configuration... so you would have
> to add initial-state also for Monk.
OK. I'll do it.
>
> But how about doing opposite? Configure here the pins to unused state
> and enable them only for Artik board?
>
> What do you think?
I think that gpk2-[0~6] pins are fixed for MMC2 device.
So, it is good to add the pin setting for gpk2-[0~6] to exynos3250-pinctrl.dtsi.
If mmc2 device is not used like rinato and monk board,
we should add the initial setting as NC (not connected) pin state
as other patch (ARM: dts: Add initial pin configuration for exynos3250-rinato).
Best Regards,
Chanwoo Choi
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
