On Sun, Nov 22, 2015 at 04:19:50PM -0600, Rob Herring wrote:
> On Sun, Nov 22, 2015 at 04:57:33PM +0100, Hans de Goede wrote:
> > From: Sander Vermin <sander@xxxxxxxxx>
> >
> > On some devices the wake and enable pins of the pixcir touchscreen
> > controller are connected to gpios and these must be controlled by the
> > driver for the device to operate properly.
> >
> > Signed-off-by: Sander Vermin <sander@xxxxxxxxx>
> > Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
> > ---
> > Changes in v2 (Hans de Goede):
> > -Split the changes for dealing with inverted / swapped axis out into a
> > separate patch
> > -Remove a bunch of dev_info calls to make the driver less chatty
> > -Use devm_gpiod_get_optional as these new gpios are optional
> > -Only msleep after setting enable high if we have an enable pin
> > Changes in v3 (Hans de Goede):
> > -Use "if (ts->gpio_foo)" instead of "if (!IS_ERR_OR_NULL(ts->foo))"
> > -No need to set gpio-s to 1 after requesting them with GPIOD_OUT_HIGH
> > ---
> > .../bindings/input/touchscreen/pixcir_i2c_ts.txt | 2 ++
>
> For the binding:
>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
Applied, thank you.
>
> > drivers/input/touchscreen/pixcir_i2c_ts.c | 40 ++++++++++++++++++++++
> > 2 files changed, 42 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/input/touchscreen/pixcir_i2c_ts.txt b/Documentation/devicetree/bindings/input/touchscreen/pixcir_i2c_ts.txt
> > index 8eb240a..72ca5ec 100644
> > --- a/Documentation/devicetree/bindings/input/touchscreen/pixcir_i2c_ts.txt
> > +++ b/Documentation/devicetree/bindings/input/touchscreen/pixcir_i2c_ts.txt
> > @@ -10,6 +10,8 @@ Required properties:
> >
> > Optional properties:
> > - reset-gpio: GPIO connected to the RESET line of the chip
> > +- enable-gpios: GPIO connected to the ENABLE line of the chip
> > +- wake-gpios: GPIO connected to the WAKE line of the chip
> >
> > Example:
> >
> > diff --git a/drivers/input/touchscreen/pixcir_i2c_ts.c b/drivers/input/touchscreen/pixcir_i2c_ts.c
> > index 211408c..22a67c6 100644
> > --- a/drivers/input/touchscreen/pixcir_i2c_ts.c
> > +++ b/drivers/input/touchscreen/pixcir_i2c_ts.c
> > @@ -38,6 +38,8 @@ struct pixcir_i2c_ts_data {
> > struct input_dev *input;
> > struct gpio_desc *gpio_attb;
> > struct gpio_desc *gpio_reset;
> > + struct gpio_desc *gpio_enable;
> > + struct gpio_desc *gpio_wake;
> > const struct pixcir_i2c_chip_data *chip;
> > int max_fingers; /* Max fingers supported in this instance */
> > bool running;
> > @@ -208,6 +210,11 @@ static int pixcir_set_power_mode(struct pixcir_i2c_ts_data *ts,
> > struct device *dev = &ts->client->dev;
> > int ret;
> >
> > + if (mode == PIXCIR_POWER_ACTIVE || mode == PIXCIR_POWER_IDLE) {
> > + if (ts->gpio_wake)
> > + gpiod_set_value_cansleep(ts->gpio_wake, 1);
> > + }
> > +
> > ret = i2c_smbus_read_byte_data(ts->client, PIXCIR_REG_POWER_MODE);
> > if (ret < 0) {
> > dev_err(dev, "%s: can't read reg 0x%x : %d\n",
> > @@ -228,6 +235,11 @@ static int pixcir_set_power_mode(struct pixcir_i2c_ts_data *ts,
> > return ret;
> > }
> >
> > + if (mode == PIXCIR_POWER_HALT) {
> > + if (ts->gpio_wake)
> > + gpiod_set_value_cansleep(ts->gpio_wake, 0);
> > + }
> > +
> > return 0;
> > }
> >
> > @@ -302,6 +314,11 @@ static int pixcir_start(struct pixcir_i2c_ts_data *ts)
> > struct device *dev = &ts->client->dev;
> > int error;
> >
> > + if (ts->gpio_enable) {
> > + gpiod_set_value_cansleep(ts->gpio_enable, 1);
> > + msleep(100);
> > + }
> > +
> > /* LEVEL_TOUCH interrupt with active low polarity */
> > error = pixcir_set_int_mode(ts, PIXCIR_INT_LEVEL_TOUCH, 0);
> > if (error) {
> > @@ -343,6 +360,9 @@ static int pixcir_stop(struct pixcir_i2c_ts_data *ts)
> > /* Wait till running ISR is complete */
> > synchronize_irq(ts->client->irq);
> >
> > + if (ts->gpio_enable)
> > + gpiod_set_value_cansleep(ts->gpio_enable, 0);
> > +
> > return 0;
> > }
> >
> > @@ -534,6 +554,26 @@ static int pixcir_i2c_ts_probe(struct i2c_client *client,
> > return error;
> > }
> >
> > + tsdata->gpio_wake = devm_gpiod_get_optional(dev, "wake",
> > + GPIOD_OUT_HIGH);
> > + if (IS_ERR(tsdata->gpio_wake)) {
> > + error = PTR_ERR(tsdata->gpio_wake);
> > + if (error != -EPROBE_DEFER)
> > + dev_err(dev, "Failed to get wake gpio: %d\n", error);
> > + return error;
> > + }
> > +
> > + tsdata->gpio_enable = devm_gpiod_get_optional(dev, "enable",
> > + GPIOD_OUT_HIGH);
> > + if (IS_ERR(tsdata->gpio_enable)) {
> > + error = PTR_ERR(tsdata->gpio_enable);
> > + if (error != -EPROBE_DEFER)
> > + dev_err(dev, "Failed to get enable gpio: %d\n", error);
> > + return error;
> > + }
> > + if (tsdata->gpio_enable)
> > + msleep(100);
> > +
> > error = devm_request_threaded_irq(dev, client->irq, NULL, pixcir_ts_isr,
> > IRQF_TRIGGER_FALLING | IRQF_ONESHOT,
> > client->name, tsdata);
> > --
> > 2.5.0
> >
> > --
> > To unsubscribe from this list: send the line "unsubscribe devicetree" in
> > the body of a message to majordomo@xxxxxxxxxxxxxxx
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
--
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
