> Op 20 december 2016 om 17:13 schreef Francois Lafont <francois.lafont.1978@xxxxxxxxx>: > > > On 12/20/2016 10:02 AM, Wido den Hollander wrote: > > > I think it is commit 0cdf3bc875447c87fdc0fed29831554277a3774b: https://github.com/ceph/ceph/commit/0cdf3bc875447c87fdc0fed29831554277a3774b > > Thanks Wido but in fact I have doubts... > > > It invokes a start after the package install/upgrade. Since you have manually stopped the daemons they will be started again. > > Yes, that seems to be logical but I have checked with the 10.2.1 > version for instance and I have these lines too in the ceph-osd > postinst: > > case "$1" in > configure) > [ -x /sbin/start ] && start ceph-osd-all || : > > and I'm pretty sure that during the 10.2.0 => 10.2.1 upgrade > the osd daemons weren't started again (after I have manually > stopped the daemons). I'm pretty because my process is manual > but it's a note I follow "idiotically" and I'm sure that I have > notice the change with the 10.2.5 version. > > However, between 10.2.1 and 10.2.5 I have noticed this diff > in the postinst: > > ---------------------------------------------------- > # Automatically added by dh_systemd_enable > # This will only remove masks created by d-s-h on package removal. > deb-systemd-helper unmask ceph-osd.target >/dev/null || true > > # was-enabled defaults to true, so new installations run enable. > if deb-systemd-helper --quiet was-enabled ceph-osd.target; then > # Enables the unit on first installation, creates new > # symlinks on upgrades if the unit file has changed. > deb-systemd-helper enable ceph-osd.target >/dev/null || true > else > # Update the statefile to add new symlinks (if any), which need to be > # cleaned up on purge. Also remove old symlinks. > deb-systemd-helper update-state ceph-osd.target >/dev/null || true > fi > # End automatically added section > # Automatically added by dh_systemd_start > if [ -d /run/systemd/system ]; then > systemctl --system daemon-reload >/dev/null || true > deb-systemd-invoke start ceph-osd.target >/dev/null || true > fi Well, that part seems to start OSDs using systemd as far as I can tell. Might explain it. Wido > # End automatically added section > ---------------------------------------------------- > > I don't know if it can explain the change I have noticed... > Currently I'm lost. As you said Wido, the line "... start ceph-osd-all..." > should start again the osd daemons manually stopped by > myself but this line is present since 10.2.1 at least and > I pretty sure that I hadn't this behavior with 10.2.1. > _______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
 |