Re: Possible improvements for a slow write speed (excluding independent SSD journals)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi

I have been testing the Samsung 840 Pro (128gb) for quite sometime and I can also confirm that this drive is unsuitable for osd journal. The performance and latency that I get from these drives (according to ceph osd perf) are between 10 - 15 times slower compared to the Intel 520. The Intel 530 drives are also pretty awful. They are meant to be a replacement of the 520 drives, but the performance is pretty bad.

I have found Intel 520 to be a reasonable drive for performance per price, for a cluster without a great deal of writes. However they do not make those anymore.

Otherwise, it seems that the Intel 3600 and 3700 series is a good performer and has a much longer life expectancy.

Andrei

From: "Eneko Lacunza" <elacunza@xxxxxxxxx>
To: "J-P Methot" <jpmethot@xxxxxxxxxx>, "Christian Balzer" <chibi@xxxxxxx>, ceph-users@xxxxxxxxxxxxxx
Sent: Tuesday, 21 April, 2015 8:18:20 AM
Subject: Re: Possible improvements for a slow write speed (excluding independent SSD journals)

Hi,

I'm just writing to you to stress out what others have already said,
because it is very important that you take it very seriously.

On 20/04/15 19:17, J-P Methot wrote:
> On 4/20/2015 11:01 AM, Christian Balzer wrote:
>>
>>> This is similar to another thread running right now, but since our
>>> current setup is completely different from the one described in the
>>> other thread, I thought it may be better to start a new one.
>>>
>>> We are running Ceph Firefly 0.80.8 (soon to be upgraded to 0.80.9). We
>>> have 6 OSD hosts with 16 OSD each (so a total of 96 OSDs). Each OSD
>>> is a
>>> Samsung SSD 840 EVO on which I can reach write speeds of roughly 400
>>> MB/sec, plugged in jbod on a controller that can theoretically transfer
>>> at 6gb/sec. All of that is linked to openstack compute nodes on two
>>> bonded 10gbps links (so a max transfer rate of 20 gbps).
>>>
>> I sure as hell hope you're not planning to write all that much to this
>> cluster.
>> But then again you're worried about write speed, so I guess you do.
>> Those _consumer_ SSDs will be dropping like flies, there are a number of
>> threads about them here.
>>
>> They also might be of the kind that don't play well with O_DSYNC, I
>> can't
>> recall for sure right now, check the archives.
>>   Consumer SSDs universally tend to slow down quite a bit when not
>> TRIM'ed
>> and/or subjected to prolonged writes, like those generated by a
>> benchmark.
> I see, yes it looks like these SSDs are not the best for the job. We
> will not change them for now, but if they start failing, we will
> replace them with better ones.
I tried to put a Samsung 840 Pro 256GB in a ceph setup. It is supposed
to be quite better than the EVO right? It was total crap. No "not the
best for the job". TOTAL CRAP. :)

It can't give any useful write performance for a Ceph OSD. Spec sheet
numbers don't matter for this, they don't work for ceph OSD, period. And
yes, the drive is fine and works like a charm in workstation workloads.

I suggest you at least get some intel S3700/S3610 and use them for the
journal of those samsung drives, I think that could help performance a lot.

Cheers
Eneko

--
Zuzendari Teknikoa / Director Técnico
Binovo IT Human Project, S.L.
Telf. 943575997
       943493611
Astigarraga bidea 2, planta 6 dcha., ofi. 3-2; 20180 Oiartzun (Gipuzkoa)
www.binovo.es

_______________________________________________
ceph-users mailing list
ceph-users@xxxxxxxxxxxxxx
http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com

_______________________________________________
ceph-users mailing list
ceph-users@xxxxxxxxxxxxxx
http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com

[Index of Archives]     [Information on CEPH]     [Linux Filesystem Development]     [Ceph Development]     [Ceph Large]     [Ceph Dev]     [Linux USB Development]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [xfs]


  Powered by Linux