On 8/6/2015 4:39 PM, Chris Murphy wrote:
On Thu, Aug 6, 2015 at 2:29 PM, Bowie Bailey <Bowie_Bailey@xxxxxxx> wrote:
On 8/6/2015 4:21 PM, Chris Murphy wrote:
On Thu, Aug 6, 2015 at 2:08 PM, Bowie Bailey <Bowie_Bailey@xxxxxxx> wrote:
Doing a new install on the two 1TB drives is my current plan. If that
works, I can connect the old drive, copy over all the data, and then try
to
figure out what I need to do to get all the programs running again.
Sounds like a pain. I would just adapt the CentOS 6 program.log
commands for your case. That's a 2 minute test. And it ought to work.
I'm not familiar with that. How would I go about adapting the CentOS 6
program.log commands?
I mentioned it in the last two posts yesterday on this subject.
Ok. I'll give that a try tomorrow. Just a couple of questions.
install --stage2=/boot/grub/stage2 /grub/stage1 d (hd0,1) /grub/stage2 p
(hd0,1)/grub/grub.conf
It looks like this mixes paths relative to root and relative to /boot.
Did your test system have a separate /boot partition? The --stage2
argument is "os stage2 file" according to my man page. Should this be
relative to root even with a separate /boot partition?
Also, why are the exact same root and install commands run twice in the
log you show? Is that just a duplicate, or does it need to be run twice
for some reason?
grub> root (hd0,1)
grub> install --stage2=/boot/grub/stage2 /grub/stage1 d (hd0,1)
/grub/stage2 p (hd0,1)/grub/grub.conf
grub> root (hd0,1)
grub> install --stage2=/boot/grub/stage2 /grub/stage1 d (hd0,1)
/grub/stage2 p (hd0,1)/grub/grub.conf
--
Bowie
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
