On Thu, Aug 6, 2015 at 2:08 PM, Bowie Bailey <Bowie_Bailey@xxxxxxx> wrote: > Doing a new install on the two 1TB drives is my current plan. If that > works, I can connect the old drive, copy over all the data, and then try to > figure out what I need to do to get all the programs running again. Sounds like a pain. I would just adapt the CentOS 6 program.log commands for your case. That's a 2 minute test. And it ought to work. Clearly the computer finds the drive, reads the MBR and executes stage 1. The missing part is it's not loading or not executing stage 2 for some reason. I'm just not convinced the bootloader is installed correctly is the source of the problem with the 2nd drive. It's not like the BIOS or HBA card firmware is going to faceplace right in between stage 1 and stage 2 bootloaders executing. If there were a problem there, the drive simply doesn't show up and no part of the bootloader gets loaded. -- Chris Murphy _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos