Its in the manual I suspect.
On Thu, 25 May 2017, Linux for blind general discussion wrote:
I think the command set was a control-e followed by a character v for volume,
r for rate, p for pitch. Then you had nine levels
sample: control-er9 set the fastest rate.
Could be wrong.
On 5/25/2017 10:26 PM, Linux for blind general discussion wrote:
On Fri, May 26, 2017 at 12:16:09PM AEST, Linux for blind general
discussion wrote:
> Hi Mark,
> Santa has come early if you have an interest.
> I have for you a copy of the documentation for the artic transport.
Does that documentation happen to also contain the command set to talk to
the
transport hardware?
Luke
_______________________________________________
Blinux-list mailing list
Blinux-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/blinux-list
_______________________________________________
Blinux-list mailing list
Blinux-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/blinux-list
_______________________________________________
Blinux-list mailing list
Blinux-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/blinux-list