[quoted lines by Thomas Stivers on June 21, 2003, at 23:35] >I am not sure how it should be configured. doing that command gives me >the following. The settings for the device look good. >I am also not sure why ttyS3 is used, but that is what the second serial port >on this computer is configured as. It's because that device is configured to use I/O port 2E8 and IRQ 3. It'll be set up that way in your BIOS. There's no particular need to change it unless, of course, something else on your system is also using IRQ 3. If you run brltty with -linfo, does it confirm that it's using /dev/ttyS3? -- Dave Mielke | 2213 Fox Crescent | I believe that the Bible is the Phone: 1-613-726-0014 | Ottawa, Ontario | Word of God. Please contact me EMail: dave@xxxxxxxxx | Canada K2A 1H7 | if you're concerned about Hell. http://familyradio.com/ | http://mielke.cc/bible/ _______________________________________________ Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list