Promise Fasttrack s150 TX4 raid issues

[Jim Perrin <perrin@xxxxxxxx>]

I recently purchased the Promise Fasttrack s150 TX4 because it was one of 
the cheaper cards that boasted linux support. I'me becoming a bit irritated 
with it though as it does not list any actual device in /dev/rd/* that I 
can see. Has anyone succesfully set this card up with raid? I can access 
the individual drives using /dev/sda etc, but what do I use to access the 
raid array? Below is output from /proc in case it's needed.

Any help would be immensely welcome.


******
[evo@insanity evo]$ cat /proc/scsi/ft3xx/0
PROMISE FastTrak TX4000/376/378/S150 TX Series Linux Driver Version 
1.00.0.15
Adapter1  - FastTrak S150 TX4
Array     - Array[1] : 1+0 Stripe (OK)
Drive     -
 1 : ST3120026AS           IDE1/Master 120033MB IRQ(24) UDMA5 Array[1]

*****
[evo@insanity evo]$ cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 01 Id: 00 Lun: 00
 Vendor: Promise  Model: 1+0 Stripe/RAID0 Rev: 1.10
 Type:   Direct-Access                    ANSI SCSI revision: 02
Host: scsi0 Channel: 02 Id: 00 Lun: 00
 Vendor: Promise  Model: 1+0 Stripe/RAID0 Rev: 1.10
 Type:   Direct-Access                    ANSI SCSI revision: 02
Host: scsi0 Channel: 03 Id: 00 Lun: 00
 Vendor: Promise  Model: 1+0 Stripe/RAID0 Rev: 1.10
 Type:   Direct-Access                    ANSI SCSI revision: 02