Hi. I've a problem with onboard pdc20265 (my board is A7V133 from Asus)
trying to boot from array. When using RedHat 7.2 original kernel source
(2.4.7-10) it boots up fine - ataraid is version 0.02. When using any newer
kernel (ataraid 0.03beta), even redhat one, it fails. I've tried 2.4.10,
2.4.17 and 2.4.18 and some others. 2.5 does not compile for me. I'm not
sure its ataraid code problem, because overwriting ataraid and pdcraid with
older ones does not help. Any suggestions?
Here is a snip from booting:
PDC20265: IDE controller on PCI bus 00 dev 88
PCI: Found IRQ 10 for device 00:11.0
PDC20265: chipset revision 2
ide: found promise 20265 in RAID mode.
PDC20265: not 100% native mode: will probe irqs later
PDC20265: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
ide2: BM-DMA at 0x8400-0x8407, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0x8408-0x840f, BIOS settings: hdg:pio, hdh:pio
hde: IC35L020AVER07-0, ATA DISK drive
hdg: IC35L020AVER07-0, ATA DISK drive
ide2 at 0x9800-0x9807,0x9402 on irq 10
ide3 at 0x9000-0x9007,0x8802 on irq 10
blk: queue c02a245c, I/O limit 4095Mb (mask 0xffffffff)
hde: 40188960 sectors (20577MB) w/1916KiB Cache, CHS=39870/16/63, UDMA(100)
blk: queue c02a27a8, I/O limit 4095Mb (mask 0xffffffff)
hde: 40188960 sectors (20577MB) w/1916KiB Cache, CHS=39870/16/63, UDMA(100)
Partition check:
hde: [PTBL] [2501/255/63] hde1 hde2 hde3
hdg: unknown partition table
ataraid/d0: ataraid/d0p1 ataraid/d0p2 ataraid/d0p3
Drive 0 is 19623Mb (33 / 0)
Drive 1 is 19623Mb (34 / 0)
Raid0 array consists of 2 drives.
Promise Fasttrak(tm) Softwareraid driver for linux version 0.03beta
VFS: Cannot open root device "ataraid/d0p3" or 00:0a
Please append a correct "root=" boot option
Kernel panic: VFS: Unable to mount root fs on 00:0a
